2. Computers & electronics
  3. Networking
  4. Gateways/controllers
  5. Anybus
  6. AB7647

Anybus AB7647 Installation guide

  • Hello! I've read the Network Installation Sheet for the Anybus X-gateway DeviceNet Scanner Interface and I'm ready to assist you. This document provides details on mounting the interface on the device, configuring the baud rate and MAC ID using DIP switches, and understanding the LED indicators. The document also covers connection options including DeviceNet and USB. I can help you with any questions about device setup, its functionality or other information present in the document.
  • Where can I mount the DeviceNet Scanner interface?
    How do I configure the baud rate?
    How is MAC ID configured?
    What kind of power supply is required?
    What connectors are available?
Anybus X-gateway - DeviceNet™ Scanner Interface Network Installation Sheet
www.anybus.comSP1757, rev. 2.10, Sep 2015
Product Overview
The DeviceNet Scanner interface can only be mounted in the top slot
of the Anybus X-gateway.
Top view
Configuration SwitchesDeviceNet Connector (X1)
Power Connector (X3)
Front view
GW Status
NS
MS
RUN
USB Connector (X4)
Status LED:s
ODVA™ and DeviceNet™ are trademarks of ODVA, Inc.
LED Indicators
LED Indication Meaning
GW Status See Gateway Installation Sheet
NS
Green Link OK, online, connected
Green (fl ashing) Online, not connected
Red Critical link failure
Red (fl ashing) Connection timeout
MS
Green Normal operation
Green (fl ashing) Data size error
Red Major fault, unrecoverable
Red (fl ashing) Minor fault, recoverable
RUN Green Run mode
Green (fl ashing) Idle mode
Technical Support
Technical support, documentation and software downloads are
available at www.anybus.com.
Technical questions regarding the DeviceNet fi eldbus system should
be addressed to ODVA at www.odva.org.
Accessories Checklist
The following items are required for installation:
• DeviceNet confi guration tool (optional, not included)
• USB cable (included)
• EDS fi le for DeviceNet (see www.anybus.com)
• DeviceNet connector (included)
• Termination resistor1 (optional, not included)
• 11–25 VDC bus interface power source according to DeviceNet
specifi cation (optional, not included)
Installation and Startup Summary
1. Set the baud rate and MAC ID using the DIP switches
2. Connect the gateway to the network
3. Attach a termination resistor1 (optional)
4. Connect a PC to the gateway via USB
5. Power up and confi gure the gateway
6. Install the EDS fi le in the DeviceNet confi guration tool (optional)
7. Perform the DeviceNet scanlist confi guration (optional)
1 If the node is installed at the end of the bus
Confi guration Switches
Baud Rate
ON
123 4 5 6 7 8
Switches 1 and 2 are used in combination to
select the Baud rate:
Switch position Baud rate
12
OFF OFF 125 k
OFF ON 250 k
ON OFF 500 k
ON ON (reserved)
MAC ID
ON
123 4 5 6 7 8
Switches 3 to 8 are used to set the MAC ID
in binary format:
Switch position MAC ID
(example)
345678
OFF OFF OFF OFF OFF OFF 0
OFF OFF OFF OFF OFF ON 1
ON ON ON ON ON ON 63 (32+16+8+4+2+1)
DeviceNet Connector
Pin Signal
51
1V -
2 CAN L
3 Ground
4 CAN H
5V +
/