If the LED on the handle flashes and three sounds are repeated twice signal, This means What V work
instrument arose error. State mistakes signalled if jug or whisk missing jug is removed during cooking or starting
work cycle with an empty jug. In the first two cases, the cycle is not starts, while in two the last cycle is started, but
stops after a few seconds.
Insert the plug into the socket.
LED (8) starts flashing. Approximately through 120 seconds inaction device passes V mode expectations And
Light-emitting diode turns off.
Heating or frothing milk
Remove the lid (4) and pour cold milk into a jug (2), keeping an eye on the level by marks engraved on the
inside of the jug.
Replace the cover (4).
Select the desired program by turning handle (7) before level red labels on ring pens.
The device will switch from the mode standby mode.
Press the START / STOP button (6) to start of the cycle, while the LED (8) will light up and stay on without
blinking.
Beep and LED off (8) point out What cycle ended.
The cycle can be stopped before the set time by pressing the START / STOP button (6).
Remove the cover (4) by grasping it at the side you ribs.
Remove the jug (2) and pour in the frothed milk, helping yourself with a spoon.
Adding sugar or sweets syrups (such as honey, juice agaves or maple syrup, etc. etc.) it is recommended to
produce at the end of the cycle.
Chocolate making
Remove the lid (4) and place in a jug (2) chocolate ingredients, following level according to the marks engraved
on the inside of the jug, and guided by the recommendations contained in the Smeg recipe.
Select the appropriate program And act Tokay, How described for milk.
Can be removed while working measuring cap (5) for adding any powdered ingredients. It is
recommended to add them slowly And small quantities through some seconds after start cycle, to give milk
warm up. The addition made too fast or excessive amounts may stop rotation corolla or to its displacement in
wrong position.
Manual mode
Remove the lid (4) and pour milk into the jug (2), keeping an eye on the level marks engraved on the inside
side pitcher.
Replace cover (4).
You can choose hot or cold foaming.