2. DANCO
  3. 80156

DANCO 80156 Operating instructions

  • Hello! I've reviewed the installation instructions for the Closet Bolt 1/4" x 2-1/4". This document provides step-by-step guidance on how to install the bolts, including the use of the square retainer washer and the wax ring. I'm ready to answer any questions you have about the process or the components.
  • What tools are required for installation?
    How do I insert the bolts?
    What is the purpose of the square retainer washer?
CLOSET BOLTS
PERNOS DEL INODORO
1/4" x 2-1/4"
Contains:
• 2 Bolts
• 2 Nuts
• 2 Washers
Instructions
Tools Required: Screwdriver
1. Insert bolts into flange with thread
facing up. The bolt goes into a keyed
opening in the flange from the top side.
Slide square retainer washer down bolt
to hold it upright.
2. Apply wax ring to hole of toilet. Align
holes in bowl with closet bolts and
carefully lower bowl.
3. Assemble washer and nut to closet
bolt and tighten.
4. Install cap.
Instrucciones
Herramientas necesarias: destornillador
1. Insertar los pernos en la brida con la rosca
hacia arriba. El perno entra en una abertura
enchavetada en la brida desde el lado superior.
Desliza la arandela cuadrada de retención
hacia abajo para mantener el perno en
posición vertical.
2. Aplica el anillo de cera al orificio del inodoro.
Alinea los orificios de la taza con pernos de
inodoro y baja cuidadosamente la taza.
3. Monte la arandela y la tuerca en el perno del
inodoro y ajuste.
4. Instale la tapa.
Nut
Tuerca
Cap / Tapa
Washer / Arandela
Wax Gasket
Empaquetadera
encerada
Closet Flange
Brida del
inodoro
Closet Bolt
Taza de inodoro
80156
/