.
1 6 0 0 - L B . S I N G L E - S P E E D
T R A I L E R W I N C H
OWNER’S MANUAL
WARNING: Read carefully and understand all
INSTRUCTIONS before operating. Failure to follow the
safety rules and other basic safety precautions may result
in serious personal injury.
Item #148819
Page of 4
2
Thank you very much for choosing a NORTHERN TOOL + EQUIPMENT CO., INC. Product! For
future reference, please complete the owner’s record below:
Model: _______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the entire manual
to become familiar with this product before you begin using it.
This machine is designed for certain applications only. Northern Tool + Equipment cannot be
responsible for issues arising from modification. We strongly recommend this machine is not
modified and/or used for any application other than that for which it was designed. If you have
any questions relative to a particular application, DO NOT use the machine until you have first
contacted Northern Tool + Equipment to determine if it can or should be performed on the
product.
For technical questions please call 1-800-222-5381.
DESCRIPTION AND INTENDED USE
For safer, easier boat loading and unloading.
TECHNICAL SPECIFICATIONS
Item
Description
Capacity
1600 Lbs. (726 kg)
Drum capacity
5/16in. x 58ft. (8mm x 17.5m)
Gear ratio
5.1:1
Speed
1-speed
Cable
Not included
Save These Instructions
CAUTION: Do not attempt to operate the hand winch until you have read and understood this
instruction manual.
1. Never overload!
2. This winch is designed for pulling, not for lifting!
3. Never put your hand or anything else near the gear, rim and rolling cable (not included; must
be added separately). Always wear gloves when using the winch.
4. Never try to repair or disassemble the winch when there is a problem. Take the winch to a
qualified repair center.
5. When replacing the cable or strap, make sure that the end of the cable or strap comes
through the 4 holes on the side of the rim, and tie a knot in the strap or cable (or weld the end
tip of cable to the cable), to prevent the cable or strap from coming out. Then reel the cable or
strap by cranking the handle.
6. Use grease for axis and gears before depositing for a long time.
7. After moving the item, be sure to secure it. The winch is intended for short term use only.
8. Keep children and bystanders away while using the trailer winch.
9. Keep at least 4 full turns of the cable or strap on the reel when pulling.
Page of 4
3
WARNING: The warnings, cautions and instructions in this manual cannot cover all possible
conditions or situations that could occur. It must be understood by the operator that common sense
and caution are factors that cannot be built into this product, but must be supplied by the operator.
OPERATING INSTRUCTIONS
1. Ratchet switch — There are 3 positions for this ratchet switch: The higher position is for
pulling, the lower position is for releasing, the middle position is for both pulling and releasing,
but can only be used when the winch is loaded. Hold the crank handle tightly if you want to
change the switch position.
2. Before using, install the winch on a firm and flat surface. To install it, put the ratchet switch on
the middle position and pull the cable out until the holes on the bottom of the base are visible.
Then use at least 3 sets of 3/8in. bolts and locking nuts, in a triangular pattern, to affix the
base to the surface. Use an extra metal or hardwood board when necessary.
3. Then install the crank handle to the axis bolt with nut.
4. Put the ratchet switch on the higher position and turn the crank handle clockwise to pull. Put
the ratchet switch on the lower position and turn the crank handle counterclockwise to
release.
Page of 4
4
DIAGRAM & PARTS LIST
Part#
Description
1
Crank handle
2
Ratchet switch
3
Axis bolt
4
Base
5
Rim
WARRANTY
Two-Year Limited Warranty
Distributed by
Northern Tool + Equipment Co., Inc.
Burnsville, Minnesota 55306-6936
Made in China
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Power Fist 8900698 Owner's manual
-
-
-
-
-
-
-
Bulldog 180455 User manual
-
-
Wallenstein CT16 User manual
