2. Magnescale
  3. LG20

Magnescale LG20, LH70, LH71 Owner's manual

  • Hello! I've reviewed the user manual for the Magnescale preset operation devices LH71, LH70, LG20, and LH72. This document explains how to set and recall preset values, including features like saving multiple presets per axis and using different numeric input methods. I'm ready to answer your questions about setting and recalling these values, as well as any other related procedure described in the document.
  • How many preset values can be saved?
    What is the display behavior during preset mode?
    How do you recall preset values?
    Can I use preset values on all the available axis?
1/１
Preset operation (LH72)
Enter the set value with the numerical keys and confirm the value with key.
Example: -15.0000
This describes a preset operation that sets an arbitrary value.
Up to 3 preset values can be saved.
Preset operation (LH71, LH70, LG20)
Ver.3 (2021.1) CS&S
Makes the preset operation possible.
Press key. ( lamp lighting)
Press key for the axis you want to set.
The leftmost segment flashes.
If you have previously entered a preset value, that value will be displayed.
Up to 3 preset values can be set for each axis
You can enter the following preset values by pressing key on the axis you want to set and then pressing key.
Setting preset values
Note: INC display is fixed during preset mode
Recall preset values
If you have set preset values in the past, pressing key will display the preset values in sequence.
Preset value 1
Preset value 2
Preset value 3
Up to 3 preset values can be set for each axis
Press key to end the preset operation. ( lamp off.）
Press key to confirm the preset value you entered.
Method 2 (input all numerical values)
Method 1 (simple input)
If you have set preset values in the past, pressing key will display the preset values in sequence.
①
②
③
④
⑤
⑥
⑦
Makes the preset operation possible.
Press key. ( lamp lighting)
①
Press key for the axis you want to set.
The leftmost segment flashes.
If you have previously entered a preset value, that value will be displayed.
②
③
Press key to end the preset operation. ( lamp off.）
Press key to confirm the preset value you entered.
④
⑤
The leftmost segment flashes (Example: X-axis)
/