1. Remove the small locking screw from the
battery compartment of each Chest Plate.
Insert three AAA alkaline batteries, then
replace the battery covers and locking
screws (Figure 1).
2. Remove the small locking screw from the
battery compartment of each Hand Blaster.
Insert three LR44 alkaline batteries (button
cell batteries), then replace the battery
covers and locking screws (Figure 2).
3. Attach the elastic neck strap to the Chest
Plate by threading the strap through the
plastic loop at the top of the chest plate and
fastening the Velcro (Figure 3).
4. Place the neck strap around the user’s neck
(Figure 4).
5. Pull the waist strap around the user’s waist
and fasten the clip by putting the peg
through the plastic hole of the Chest Plate.
Lock the clip by pulling down until the peg
clicks into place (Figure 5).
6. Select the Hand Blaster of the same color
as the user’s Chest Plate and slide two to
four fingers into the Hand Blaster. The elastic bands should be around the outside of the
user’s fingers (the right hand is displayed, however the Hand Blasters can be used on
either hand) (Figure 6).
7. Press the ON/OFF button on both Chest Plates.
8. Press the ON/OFF button on both Hand Blasters. Once the Hand Blasters are turned on, the Chest
Plates will sound once to signal the corresponding Hand Blaster is paired and the Chest Plates will
display the number “8” (signifying the number of lives).
- 2 -
OPERATION
HOW TO PLAY
FIG. 1
FIG. 3 FIG. 4
FIG. 5 FIG. 6
TOP
SIDE
FIG. 7
PALM
SIDE
FIG. 2
1. To fire a laser beam from the Hand Blaster, aim the circular
light on the palm side of the user’s hand towards
the opponent’s Chest Plate (Figure 7).
2. When the Hand Blaster’s laser beam hits the opponent’s
Chest Plate, the score on the opponent’s Chest Plate will
decrease and a noise will sound.
3. Each player’s Chest Plate will show how many lives are remaining.
An alarm will sound when a player has one life left. (Continued on next page)