en-US
64
References to illustrations
The illustrations referred to in the text
ar
e shown on the fold-out pages at
the end of these Operating Instruc‐
tions.
Handheld Turbobrush features
The handheld Turbobrush is operated
by the suction power of the vacuum
clea
ner. It has a rotating roller brush
which is very effective at vacuuming up
thread, hair and fluff.
Recommended use (Fig. 01)
When using the handheld Turbo‐
bru
sh, please also observe the IM‐
PORTANT SAFETY INSTRUCTIONS
in your vacuum cleaner instruction
manual.
This handheld Turbobrush is particularly
suitable for vacu
uming upholstery, mat‐
tresses, car seats and carpeted stairs.
It is also important to observe the
floo
ring manufacturer's cleaning and
care instructions.
Fitting the handheld Turbo‐
brush
Co
nnect the handheld Turbobrush to
the handle or suction wand on your
vacuum cleaner depending on how
you wish to use it.
Using the handheld Turbo‐
brush
T
o achieve the best effect, pass the
handheld Turbobrush slowly back‐
wards and forwards over the surface
being vacuumed.
Maintenance
Always disconnect the vacuum
c
leaner from the electrical supply for
cleaning and maintenance work on
the handheld Turbobrush. Switch off
at the wall socket and unplug it.
Removing threads and hairs
(Fig. 02 - 04)
W
ith a pair of scissors (Fig. 02), cut
any threads or hairs that have beco‐
me entangled on the roller brush.
Then run the vacuum cleaner to vac‐
uum up the bits.
For more tangles or blockages inside
the handhel
d Turbobrush, the cover can
be opened. Any large particles can then
be easily removed (Fig. 03).
T
wist the connector until the release
button is located in the center of the
slot .
The
n press release button and pull
the connector away from the hand‐
held Turbobrush .
Open up the brush compartment as
far as you can and then remove any
stubborn soiling from the compart‐
ment interior and from the roller
brush (Fig. 04).