2424
en
CLEANING AND MAINTENANCE
After use (I)
1. Unplug the iron plug from the power outlet and
let it cool down.
2.
3.
store the product in a safe and dry environment.
4. When the product is not used for extended peri-
ods, it is advisable to empty the water reservoir
by inserting the tip of the iron into the appropriate
position .
Cleaning the product (J)
Do not use aggressive and/or abrasive products to
clean the plastic parts and the iron’s soleplate.
polished, prevent it from coming into contact with met-
as buttons, studs and hinges, as these may scratch
the soleplate.
1. Unplug the iron plug from the power outlet and
let it cool down.
2. Clean the upper part of the product with a soft
damp cloth then wipe it dry.
3. For routine cleaning and/or to remove stains or
other residues deposited on the soleplate, use a
soft damp cloth and dry the surface.
4. Use a damp cotton bud to remove any limescale
deposits from the steam holes, which may impair
the performance of your iron.
5. Regularly rinse the reservoir with clean water.
Always empty the water reservoir after cleaning
operations.
Descaling cycle (K)
every 10 hours of use, in order to remove any calcare-
ous salt residues from the steam chamber.
signals that the boiler must be cleaned. The product
but will have reduced performance. We recommend
turns on, according to the procedure described below.
Clean it above a container resistant to heat and far
from fabrics, to prevent these from getting stained. If
you wish to clean your product’s boiler, wait at least 3
hours until the appliance has cooled down completely.
1.
from the power outlet.
2.
3.
-
wise.
4. Empty the boiler of any residual water.
5.
product above a container resistant to heat, then
6. Insert the plug and switch the product on by
7. Keep the programme selector button pressed for
-
es. Press the programme selector button again.
8. The product will emit an acoustic signal, the li-
mescale indicator light will turn on and the wash-
ing phase will start, with water, steam and pos-
sible limescale residues coming out of the boiler.
The water and steam coming out of the boiler are
very hot and can burn your skin. Do not touch nor
close the boiler during the washing phase.
9. The washing phase lasts roughly 3 minutes.
10. A long acoustic signal and the switching off of
the washing phase. The product will switch off
automatically.
11. Disconnect the product from the power outlet.
12.
it to cool down.
13.
14. -
-
wise.
15.
position.
When the product is started again, before using the
steam function on the garments press the steam but-
particles which could stain the fabrics.
Although this product is compatible with the use of tap
water, we recommend using demineralised water on
a regular basis.
must be carried out more often.