Stairmaster HIITMill X 9-4640 Owner's manual

Install Instructions

Page 1

620-8585 Rev. B

HIIT Console Installation

Applies to: AirFit Gen1 (160002, 160003) + AirFit Gen2 (9-4580) + HIIT Bike (9-4650) + AirFit UB (9-4570) + HIIT

UBE (9-4660) + HIIT Rower (9-4690) + HIITMill (9-4590 , 9-4670) + HIITMill X (9-4640, 9-4680)

Required Tools:

• #2 Phillips Screwdriver

HIIT Bike Console Installation:

1. Before mounting the console, gently pull the

data cable from the weldment then connect the

end of the data cable to the console.

NOTE: Be sure to feed any slack data cable back into

the weldment

2. Use a phillips screwdriver to secure the HIIT

Console to the mount using four (4) M5 x 10mm

screws.

After installing the console, ensure that the unit type is set for the appropriate model:

1. Power the console on by pressing the counter-clockwise arrow.

2. Press and hold the level up, level down, and clock buttons at the same time for 3-5 seconds.

3. Use the down arrow to navigate to the 3rd page and press the clock button to change between

the following:

P1 TREAD (HIITMill) P2 BIC 1 (HIITBike/AirFit)

P3 ERGO (HIIT UBE) P4 STEP (Not used)

P5 BIC 2 (Airt Gen 1) P6 ROW (HIIT Rower)

P7-P9 NONE

4. Press the counter-clockwise arrow button to save the unit type.

This manual is also suitable for

Download PDF