2. Stairmaster
  3. HIITMill 9-4590
HIITMill 9-4590

Stairmaster HIITMill 9-4590, AirFit, AirFit G2, AirFit UB 9-4570, HIIT Bike 9-4650, HIIT Rower, HIIT UBE 9-4660, HIITMill, HIITMill X, HIITMill X 9-4640 Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Stairmaster HIITMill 9-4590 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Install Instructions
Page 1
620-8585 Rev. B
HIIT Console Installation
Applies to: AirFit Gen1 (160002, 160003) + AirFit Gen2 (9-4580) + HIIT Bike (9-4650) + AirFit UB (9-4570) + HIIT
UBE (9-4660) + HIIT Rower (9-4690) + HIITMill (9-4590 , 9-4670) + HIITMill X (9-4640, 9-4680)
Required Tools:
• #2 Phillips Screwdriver
HIIT Bike Console Installation:
1. Before mounting the console, gently pull the
data cable from the weldment then connect the
end of the data cable to the console.
NOTE: Be sure to feed any slack data cable back into
the weldment
2. Use a phillips screwdriver to secure the HIIT
Console to the mount using four (4) M5 x 10mm
screws.
After installing the console, ensure that the unit type is set for the appropriate model:
1. Power the console on by pressing the counter-clockwise arrow.
2. Press and hold the level up, level down, and clock buttons at the same time for 3-5 seconds.
3. Use the down arrow to navigate to the 3rd page and press the clock button to change between
the following:
P1 TREAD (HIITMill) P2 BIC 1 (HIITBike/AirFit)
P3 ERGO (HIIT UBE) P4 STEP (Not used)
P5 BIC 2 (Airt Gen 1) P6 ROW (HIIT Rower)
P7-P9 NONE
4. Press the counter-clockwise arrow button to save the unit type.
/