CyberData 011521, InformaCast 011521 Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the CyberData 011521 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Quick Reference 931744A © 2020, CyberData Corporation, ALL RIGHTS RESERVED.
Parts
FIts 24-inches x 24-inches and 24-inches x 48-inches ceiling tile
(1) InformaCast Enabled 2 x 2 Ceiling Tile Drop-In Speaker Assembly
Dimensions
23.8 [605]
3.0 [77]
23.8 [605]
Dimensions are in Inches [Millimeter]
Contacting CyberData
Sales: (831) 373-2601 ext. 334
Support: 831-373-2601 ext. 333
Support Website: http://support.cyberdata.net/
RMA Department: (831) 373-2601 ext. 136
RMA Email: [email protected]
RMA Status: http://support.cyberdata.net/
Warranty Information: http://support.cyberdata.net/
Corporate Headquarters
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA
Phone: 831-373-2601
Fax: 831-373-4193
http://www.cyberdata.net/
The IP Endpoint Company
Installation Quick Reference
InformaCast Enabled 2 x 2 Ceiling Tile Drop-In Speaker
011521
© 2020, CyberData Corporation, ALL RIGHTS RESERVED. 931744A Quick Reference
Installation Procedure
To install the InformaCast Enabled 2 x 2 Ceiling Tile Drop-In Speaker, complete the following steps while referencing
the figure below:
1. Remove the Ceiling Tile (Below Figure Showing a 2 x 2 Grid) from the Ceiling Grid. Cut the 2 x 4 Ceiling Tile in
Half if using a 2 x 4 Grid.
2. Place the Cross T* in the Middle for Support (Only on a 2 x 4 Grid).
3. Use a Flat Blade Screwdriver to Pry the Seismic Tether Bracket(s) on the 2 x 2 Ceiling Tile Speaker Assembly.
4. Install Eyebolt(s) or Nail(s) to the Joist.
5. Connect the Network Cable to the Network Port and Wire(s) to the Terminal Block, etc. to the 2 x 2 Ceiling Tile
Speaker Assembly.
6. Use Steel Wire(s) to Connect Seismic Tether Bracket(s) to the Eyebolt(s) or Nail(s). Place the 2 x 2 Ceiling Tile
Speaker Assembly on to the Ceiling Grid and the Cross T* (see Step 2).
Installing the InformaCast Enabled 2 x 2 Ceiling Tile Drop-In Speaker
Use a Flat Blade Screwdriver
to Pry Up the Seismic Tether Bracket
Joist
Eyebolt / Nail
*
*
*
*
Speaker Assembly
2 x 2 Ceiling Tile
Steel Wire
*
Remove
Ceiling Tile
Install Cross T (Not Included)
Only on a 2 x 4 Grid
1
2
Drop-in the 2 x 2 Ceiling Tile Speaker Assembly
6
3
4
5
Cross T
/