“APEMCO
N4297-5V4 w9a
No. 5716
DOOR/WINDOW TRANSMI-ITER
(With Built-in Reed Switch, Magnet Separate)
INSTALLATlOti INSTRUCUONS
GENERAL
The 5716 Door and Window Transmitter is small in size for unobtrusive use on doors and
windows. It transmits up to 200-feet (30m) range, indoors. The No. 5716 includes a three
minute transmit - inhibit delay. You can use this device in a normally open or normally
closed configuration. The response time is 400mS in normally closed configuration. A
built-in reed switch (magnet is sold separately) or loop terminals may be used (not both).
SPECIFICATIONS
Transmission
Frequency: 345 MHz (U.S.), 315 MHz (CANADA)
Battery: g-volt Alkaline battery.
Range: Up to 200-feet (30m) range, indoors.
BAlTERY INSTALLATION
The unit operates on a O-volt Alkaline battery. While
observing correct polarity, push battery against contacts and
wedge bottom of battery against Dip Switch SW3. Use only
Alkaline Duracell MN1604 (ADEMCO No. 464).
MOUNTING
Use only the two screws supplied. Attach wall plate,
which is included, to wall with hooks pointing up and slip
G
SW.-
keyhole slots in back case down onto hooks,
snllcn IN
OR:
yyp&y wmc$Jl “-&=+$
II
Is’
1. INSERT SMALL FLAT- BLADE SCREWDRIVER
IN PRY-OFF SLOT AT END OF UNIT AND TWIST
TO RELEASE TOP COVER.
2. CAREFULLY REMOVE PC BOARD FROM BACK
CASE.
3. ATTACH BACK CASE DIRECTLY TO WALL.
4. REPLACE PC BOARD AND TOP COVER.
TRANSMITTER ID (ZONE NUMBER)
ASSIGNMENTS
ID I-47: BURG.
ID 46-55: FIRE
ID 56-61: AUX
ID 62: PANIC
ID 63: EMERG.