Munters Convert BI28x to BI28x-PP Owner's manual

Type
Owner's manual
FORM: QM1109
Rev. 1, March 2019
Page 1 of 2
Munters Corporation
2691 Ena Dr. Lansing, MI 48917-8521 USA
(517) 676-7070 Fax (517) 676-7078 www.munters.us
INSTALLATION INSTRUCTIONS
To achieve maximum performance and insure long life from your Munters product it is essential that it be installed and
maintained properly. Please read all instructions carefully before beginning installation.
THANK YOU
PLEASE NOTE
Thank you for purchasing an BI28 conversion kit from Munters. Munters equipment is designed to be the highest performing,
highest quality equipment you can buy. With the proper installation and maintenance it will provide many years of service.
BI28x to BI28x-PP
Conversion Kit for 10 Inlets
AC1549
Place inlet actuators/switches in OFF position prior to working on inlets.
Step 1
Remove retainer screw and hinge pin from each end of inlet and either remove doors or let them hang
down from the lift line. See Figure 1.
Step 2
Remove any dirt and debris from the hinge groove on the inlet frame. Then clean groove with acetone or
rubbing alcohol. See Figure 2.
Figure 1
Retainer Screw
Hinge Pin
Figure 2
Hinge Groove
FORM: QM1109
Rev. 1, March 2019
Page 2 of 2
Munters Corporation
2691 Ena Dr. Lansing, MI 48917-8521 USA
(517) 676-7070 Fax (517) 676-7078 www.munters.us
Step 3
Install the Brush Seal in the hinge groove making sure not to cover the hole for the hinge pin. See Figure 3.
To install Brush Seal, peal white adhesive cover off and apply pressure to Brush Seal when applying.
Step 4
While holding the doors in place reinstall the hinge pins through the frame and into the door. Then reinstall
the retainer screws. See Figure 4.
Turn inlet actuators/switches back to AUTO.
Figure 3
Brush Seal
Figure 4
Retainer Screw
Hinge Pin
  • Page 1 1
  • Page 2 2

Munters Convert BI28x to BI28x-PP Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI