DDR3-1600, PC3-12800S, Unbuffered, NECC, 1.5V, 204-pin DIMMs
DRHMW8760A 31-Jul-12
Copyright 2012 Dataram Corporation | U.S.A. Headquarters +1 609-799-0071 | Offices in Europe and Asia | www.dataram.com
The information contained in this document has been carefully checked and is believed to be reliable and accurate. However, Dataram assumes no responsibility for errors.
DRHMW8760A/4GB (1 x 4GB 2Rx8 SODIMM)
DRHMW8760A/8GB (1 x 8GB 2Rx8 SODIMM)
204-pin SO-DIMM
67.6 mm wide by 30 mm high (2.661” x1.181”)
Data Transfer Rate: 12.8 Gigabytes/sec
Operating Voltage: 1.5V(1.425V~1.575V)
Fully RoHS Compliant
Each DRHMW8760A upgrades consists of a single
DDR3-1600 Unbuffered Non-ECC SO-DIMM that
conforms to JEDEC’s DDR3, PC3-12800S standard. One
2K-bit EEPROM is used for Serial Presence Detect.
DRHMW8760A/4GB
DRHMW8760A/8GB
1 x 4GB 2Rx8 PC3-12800S-11-11-F3
1 x 8GB 2Rx8 PC3-12800S-11-11-F3
Tolerances on all dimensions
except where otherwise
indicated are .15 (.0059).
All dimensions are expressed
in millimeters [inches]