Dynamode IDE-SATA-SI Datasheet

Extend your Hard Disk Lifespan.

Looking for complete flexibility when adding your existing SATA or IDE

interface Hard Disk(s) to your system?

Introducing the new Dynamode IDE-SATA-SI. A discrete, PCB level adapter

which simply connects to the rear interface of any SATA or IDE Hard Disk or

other Mass Storage Device (MSD) without taking up valuable space inside

your Desktop or Server chassis.

Allowing ‘Boot Time’ level Storage attachment, the IDE-SATA-SI needs no

software to be installed and converts SATA (Serial ATA) to ATA (Parallel ATA)

and vice versa, quickly and with minimal fuss. Comes embedded with dual

SATA Ports, one ATA/133 IDE type interface and a single 4-Pin Power

Connector.

Fully bi-directional in operation the device also comes with a unique status

LED showing data activity together with bundled SATA-SATA data cable and

4-Pin to standard ‘Molex’ Power cable.

Available now from Dynamode authorized distributors and resellers

Advanced features

Discrete PCB for direct Storage Device attachment

Needs no Drivers, converts at ‘Boot Time’

Single 40-Pin IDE Port; Two SATA Ports

Single 4-Pint Power Connector

Converts SATA to Parallel ATA

Converts Parallel ATA to SATA

Supports ATA100/133 Specification

Fully compliant with Serial ATA Specifications

Unique activity LED on PCB

Bundled ‘Molex’ Power Cable and SATA Data Cable

IDE-SATA-SI

Bi-directional IDE to SATA Adapter

Further product details available from www.dynamode.net

Details correct at going to Press. E&OE

All Trademarks Acknowledged.