P
3
READANDUNDERSTANDTHESEINSTRUCTIONSBEFOREINSTALLINGFIXTURE
INSTRUCTION SHEETNO,
Thisfixtureisintendedfor installation in aczordan~ with the National Electrical Code and local regulations,
To assure full compliance with local codes and regulations, check with your local electrical inspector before
Installation, Toprevent electrical shock, turnoff electricity at fuse box before proceeding.
IS:7596
Retainthese instructions for maintenancereference,
R0892
CONDUIT ADAPTER
FOR USE WITH BASIC LYTESPAN”TRACK SYSTEM ONLY.
The CONDUIT ADAPTER is used for power feed10theLIVE END of Basic
Lytespanfromsurfaceconduitthatterminatesin1/2-14 IPSthreadedconnector.
CAUTiON:
“ TURN OFF POWERAT FUSE BOX BEFOREInstalling
TRACK.
“ usEoNLY #12 GA, soLIDcoPPER wlREIN connectors To
MAINTAiN PROPERRATiNG OFTRACK,
PLUG
o
OBSERVEPOLARITY,WHITE(NEUTRAL)WIREMUSTBE
BOTTOM->
CONNECTEDTO TERMINAL MARKED“NEUT”, FAILURETO
COVER
OBSERVEPOLARiTY MAY RESULTINAN ELECTRICAL
HAZARD,
FIG, 1
~ DO NOTUSETRACK AS A CONDUITSUPPORT,
INDEPENDENTCONDUITSUPPORTS(SUCHAS SUiTABLE
CONDUITSTRAPS)MUST BEUSEDTOATTACH THECONDUIT
lNSTALLATiONTOTHE BUILDINGSTRUCTURE,
INSTALLATION FORBASICLYTESPAN
l, UnscrewPLUGandremoveBOTTOMCOVERfromLIVEEND(Fig,l),
2,ScrewinCONDUlTADAPTER(Fig,2),
3,Screweleckimlconnector(byothers)intoCONDUITADAPTER,Passsupplyleads
throughassemblyandfastensupplyIeadsasshown
ontrackinstructionsheet1S:6020,
NOTES:TheNUTinside the LIVE ENDcan be rotated to permit
sufficient clearance for suppiy leads. CONDUITADAPTER is NOT
required for Advent Lytespanm,
FIG. 2
[m I <> H
iC> L I E H
RRR&R<!SE!~R’
/
