Page is loading ...
# Description # Description
1
Projection lens
11
Headphone
2
Focus ring
12
Reset hole
3
Air inlet
13
HDMI/MHL connector
4
Tilt adjusting wheels
/ Flipping handle
14
5V DC output
connector
5
Air outlet 15 DC input
6
Direction keys 16 Power button
7
Volume Down 17 Kensington
TM
lock
port
8
18 Battery Indicator LED
9
Volume UP 19 Power/Charge
Indicator LED
10
MENU/Exit
1. This product can be installed in the desktop only,
otherwise lamp life could decrease dramatically.
2. Keep the power more than 30% always for better
cell life.
3. Fully recharge the power bank at least every 3
months.
4. Protect from moisture and corrosive materials.
5. The projector will automatically shutdown when
there is no signal input after 15 minutes.
6. The projector will automatically enter Eco mode for
power saving power if there is no any signal input
after 5 minutes.
7. With fast charging technology, the battery power
level will increase from 5% to 80% in approximately
3 hours and 30 minutes, and to 100% in
approximately 4 hours and 45 minutes.
8. The battery capacity will be decreased by longer
time and more recycling times.
Reminder & Maintenance
•
Output power state
Power On
Power
adaptor
Power
Battery
Power
adaptor
Power
Battery
DC 5V OUT 5V 5V 5V 5V
MHL 5V 5V X X
HDMI X X X X
Note
:
When MHL is connected to the projector, the DC 5V
OUT will not work.
•
Compatibility modes
A. HDMI-PC
Resolution Refresh rate (Hz)
SVGA/XGA/WXGA/1080p 60
B. HDMI-Video (MHL)
Resolution Refresh rate (Hz)
480i/480p/720p/1080i/1080p* 60
576i/576p/720p/1080i/1080p* 50
1080p 24
Note
:
*
MHL
is not supported.
•
LED indicator / Message
Battery status Charging Completed
POWER_LED Red Blue
Battery level BATT_LED
Message
70%
~
100% Green
The projector will
automatically
shutdown after
:
(seconds)
40%
~
70% Orange
5%
~
40% Red
< 5%
#1
10s
Fan fail
#2
30s
Projector
overheated
#2
30s
Battery
Overheat
--
Note
:
#1
The projector will automatically shutdown after event.
#2
The projector will automatically shutdown before event.
English
Intrduction
•
Product Overview
14
11
15
16
13
17
19 18
12
6
4
5
7 8 9
1
2
3
10
•
Battery discharge time under Display mode
Eco Standard Bright
HDMI
#1
O O O
Battery life
#2
(Hour)
4.5 3 2
Note
:
#1
1920x1080@60Hz
#2
•
Power
Power On Long press >1s
Short press <1s twice
Power bank
Short press <1s
under battery mode
Regulations and safety notices
FCC notice
This device has been tested and found to comply with the limits for
a Class B digital device pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This device generates, uses,
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause harmful interference
to radio or television reception, which can be determined by turning
interference by one or more of the following measures:
which the receiver is connected.
help.
Notice: Shielded cables
All connections to other computing devices must be made using
shielded cables to maintain compliance with FCC regulations.
Notice: Peripheral devices
Only peripherals (input/output devices, terminals, printers, etc.)
in interference to radio and TV reception.
Caution
could void the user's authority, which is granted by the Federal
Communications Commission, to operate this device.
Operation conditions
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Notice: Canadian users
This Class B digital apparatus complies with Canadian ICES-003.
Remarque à l'intention des utilisateurs canadiens
Cet appareil numérique de la classe B est conforme a la norme NMB-
003 du Canada.
CE declaration of conformity
We hereby declare above product is in compliance with the essential
requirements and other relevant provisions of EMC Directive 2014/30/
EU, Low Voltage Directive 2014/35/EU and RoHS Directive 2011/65/EU
and Directive 2009/125/EC with regard to establishing a framework for
the setting of ecodesign requirements for energy-related product.
Information for your safety and comfort
Read these instructions carefully. Keep this
document for future reference.
Follow all warnings and instructions marked on
the product.
Using electrical power
This product should be operated from the type
of power indicated on the marking label. If you
are not sure of the type of power available,
consult your dealer or local power company.
Product servicing
Do not attempt to service this product
yourself, as opening or removing covers may
expose you to dangerous voltage points or
service personnel.
Additional safety information
•
Do not look into the projector's lens when the
light is on. The bright may hurt your eyes.
•
Do not place the product in following
environments:
■
Locations where excessive humidity, dust, or
cigarette smoke may contaminate optical
components, shortening the life span and
darkening the image.
■
Locations with an ambient temperature
above 40 ºC/104 ºF.
•
Unplug immediately if there is something
wrong with your projector. Do not operate if
smoke, strange noise or odor comes out of
shock. In this case, unplug immediately and
contact your dealer.
•
Do not face the projector lens to the sun. It can
•
Do not look into the air outlet grille when
projector is operating. It may hurt your eyes.
Disposal instructions
Do not throw this electronic device into the
trash when discarding. To minimize pollution
and ensure utmost protection of the global
environment, please recycle. For
more information on the Waste
from Electrical and Electronics
Equipment (WEEE) regulations,
visit http://www.acer-group.
com/public/Sustainability/
sustainability01.htm
English
•
OSD function list
(By Icon) (By selection)
Display
Display Mode: Choose your preferred mode from Bright, Standard or Eco.
Brightness: Adjust the brightness of the image.
Contrast: Adjust the contrast of the image.
Projection Mode: Choose Front or Rear.
Aspect Ratio: Choose your desired aspect ratio.
Keystone Adjust image distortion caused by tilting projection.
Volume Adjust the headphone volume.
Information Display the projector information for this projector.
Language Select your preferred menu language.
Setting
Reset: Choose "Yes" to return the parameters on all menus to the factory default settings.
Note 1
:
Note 2
:
Does not guarantee the USB speaker sound quality.
Use projector in a sideway or ceiling mode
is not supported.
Consumo de Energia
En Operaction: 31.30 Wh (31,30Wh)
En modo de espera: 0.26 Wh (0,26 Wh)
http://go.acer.com/?id=17883
*36.7BR01H001-A*
36.7BR01H001-A
P/N:MC.JQC11.002
/