Samsung ET-YC200: This product helps you to take photos and videos remotely while pairing the remote control and your device via Bluetooth. It also allows you to connect your device to a tripod or mount for stable capturing, making it a great tool for photographers and videographers.
Samsung ET-YC200: This product helps you to take photos and videos remotely while pairing the remote control and your device via Bluetooth. It also allows you to connect your device to a tripod or mount for stable capturing, making it a great tool for photographers and videographers.
Printed in Korea
GH68-46227A Rev.1.0
L Type 07/2016
QUICK
START
GUIDE
ET-YC200
2
1
A
1
2
B
C
D
2
1
1
3
E
d
c
e
a
b
Copyright © 2016 Samsung Electronics
English
Bluetooth
®
is a registered trademark of Bluetooth SIG,
Inc. worldwide.
•
Please read this guide before using the device to
ensure safe and proper use.
•
Images may differ in appearance from the actual
product. Content is subject to change without prior
notice. Visit
www.samsung.com
to view device
information, the latest guide, and more.
•
Before using the value kit, make sure it is compatible
with your device.
•
Your consumer rights are governed by the law of the
country in which you purchased the product. Please
contact your service provider for more information.
Connecting the tripod
Insert the tripod into the Gear 360 and rotate it to
attach it. (
)
Connecting the mount
1. Insert the buckle into the Gear 360 and rotate the
mounting screw to attach it. (
)
2. Peel off the cover of the adhesive tape on the back
of the mount and press the mount against the target
surface to attach it. (
)
Depending on the target surface, use the flat
mount (
) or curved mount ( ).
3. Attach the Gear 360 with the buckle to the mount
until you hear a click. (
)
To remove the buckle from the mount, slide the buckle
out of the mount while pressing both sides of the buckle
and then rotate the mounting screw to remove the Gear
360 from the buckle. (
)
Make sure that you rotate the mounting screw
instead of the Gear 360 when connecting or
removing the Gear 360 from the buckle to avoid
damaging the components.
Using the remote control
Device layout
Indicator light Battery cover
Shutter key Remote control case
Power switch
Connecting the remote control to the Gear
360
Take photos and record videos remotely while pairing
the remote control and Gear 360 via Bluetooth.
1. Gear 360 Press and hold the Menu key.
2. Gear 360 Press the Menu key until Remote control
is selected, and then press the OK key to select it.
3. Remote Control Slide the Power switch to ON to
turn on the remote control.
The remote control and Gear 360 are connected to
each other and the indicator light flashes blue.
If the remote control fails to connect to the Gear
360, press and hold the Shutter key for more
than 10 seconds to reset the remote control.
Recording videos or taking photos
Press the Shutter key to take photos or record videos.
The indicator light will flash green.
Press the Shutter key again to stop recording videos. The
indicator light will flash red.
Replacing the battery
If the indicator light does not flash when you press the
Shutter key, replace the battery.
Rotate the battery cover to
to open it, and then
replace the battery.
You can only use a CR1632 battery.
Storing the remote control
Insert the remote control into the remote control case
and put the case into any leg of the tripod for easy
storage.
Safety information
Read all safety information before using the device
to ensure safe and proper use. To view the full safety
information, refer to the Samsung website.
Use manufacturer-approved accessories and
supplies
Do not touch the device with wet hands
Do not drop or cause an impact to the device
Do not bend or twist the device excessively
The device can be used in locations with an ambient
temperature of 0°C to 35°C. You can store the device
at an ambient temperature of -20°C to 50°C. Using
or storing the device outside of the recommended
temperature ranges may damage the device or
reduce the battery’s lifespan
Use the device only for their intended purposes
Do not allow children or animals to chew or suck
the device
Do not disassemble, modify, or repair your device
Make sure that the maximum adhesion of the mount
occurs after 24 hours. Do not reuse the adhesive tape
after detaching it from the surface
Español (Castellano)
Bluetooth
®
es una marca comercial registrada de
Bluetooth SIG, Inc. en todo el mundo.
•
Lea este manual antes de utilizar el dispositivo a fin de
garantizar el uso correcto y seguro.
•
Es posible que las imágenes no sean exactamente
iguales al producto real. El contenido está sujeto a
cambio sin previo aviso. Podrá acceder al manual del
usuario completo para obtener más información.
Ingrese en
www.samsung.com
para ver datos sobre el
dispositivo, el manual del usuario y muchas cosas más.
•
Antes de utilizar el otro dispositivo, asegúrese de que
sea compatible con el control remoto.
•
Sus derechos como consumidor se encuentran
regidos por la ley del país en el cual haya adquirido
el producto. Para solicitar más información,
comuníquese con su proveedor de servicios.
•
Favor de leer el manual de usuario antes de operar
el equipo.
Conectar el trípode
Inserte el trípode en el Gear 360 y gírelo para ajustarlo
(
).
Page is loading ...
-
1
-
2
Samsung ET-YC200: This product helps you to take photos and videos remotely while pairing the remote control and your device via Bluetooth. It also allows you to connect your device to a tripod or mount for stable capturing, making it a great tool for photographers and videographers.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- español: Samsung ET-YC200 Manual de usuario
- português: Samsung ET-YC200 Manual do usuário