147 Leslie Preamp
Pedal Owners Manual
GENERAL INFORMATION
Congratulations on the purchase of your new 147 Preamp Pedal! Our preamp pedals are the result of
an uncompromising dedication to meticulous crasmanship and a commitment to create unparalleled
performance for our customers.
is pedal may look like a typical stomp box, but it’s a preamp for the legendary Leslie rotary speaker
cabinets. Plug your guitar (1/4” T/S high impedance input) or keyboard (1/4” T/R/S stereo low
impedance input), and connect this preamp to your Leslie via a standard 6 pin Leslie cable. Controls
include gain, tone, speed, and power on/o.
All Analog Outtter preamp pedals are built with vintage multi-pin Leslie connectors and an original
circuit design that is hand-wired to capture the true soul of a Leslie. We are proud to deliver an
unrivaled tone in a sleeker and more durable enclosure.
SAFETY INSTRUCTIONS
SPECIFICATIONS
8” x 5 /” x 4 /”
3.3 lbs
6 Pin Leslie Cable Output
DIMENSIONS:
WEIGHT:
ADDITIONAL FEATURES:
CAUTION:
RISK OF ELECTRIC SHOCK
DO NOT OPEN!
REFER SERVICING TO QUAULIFIED SERVICE PERSONNEL
NO USER SEVERICEABLE PARTS INSIDE
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
EQUIPMENT TO MOISTURE.
CAUTION:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THE
EQUIPMENT TO RAIN OR MOISTURE
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE.
User’s Guide
FRONT PANEL
BACK PANEL
1. ON/OFF: Flip switch to the le to turn preamp on, ip to switch to the right to turn back o.
2. AC INPUT: e power supply of the 147 Preamp Pedal will work with everything between 100 -240
volts.
3. GUITAR INPUT: ¼” instrument level input jack for use with passive instruments like guitar.
4. 147 ONLY: e preamp is built to be compatible with Leslie 147 ampliers (or compatible Leslie
6W style interfaces), please check the amplier in your Leslie to make sure you purchase the correct
preamp.
5. LINE INPUT: ¼” input jack for use with active instruments like a keyboard.
1
3
4
2
5
NOTE: When connecting
a Leslie to this preamp
always line up the dot on
the Leslie cable with the
dot on the 6 pin Leslie
connector.
1 2
3
5
1. GAIN: Control overall level of the output for the preamplier.
2. TONE: Attenuate the high frequencies.
3. SPEED LIGHT: e speed light indicator will turn green when the speed switch is set to fast, the
indicator will turn red when the speed is switched to slow.
4. PILOT LIGHT: is power indicator will light up when power is switched on.
5. SPEED SWITCH: e speed switch will set your Leslie motor to one of two speeds: fast or slow.
4
100
REPAIRS
We thoroughly test each preamp pedal before it leaves our shop in order to make sure you are
getting nothing less than optimal performance and tone. We stand behind our products with a
3-year limited warranty on parts and labor.
However, if your preamp requires repair or maintenance for any reason, please reach out to Analog
Outtters for help before going to another technician. Email info@analogouttters.com or call
217.954.1805 for any questions or concerns.
For any questions or concerns, please contact Analog Outtters:
info@analogouttters.com | 217.954.1805 | www.AnalogOuttters.com
/
