90 CM ELECTRIC INDUCTION COOKTOP INSTALLATION
INSTRUCTION
INSTRUCCIONES DE INSTALACIÓN DE LA SUPERFICIE DE
COCCIÓN POR INDUCCIÓN ELÉCTRICA DE 90 CM
Table of Contents / Tabla de contenidos
COOKTOP SAFETY ...................................................... 2
INSTALLATIONS REQUIREMENTS ............................. 3
Tools and parts ........................................................... 3
Location Requirements .............................................. 3
Electrical Requirements .............................................. 5
INSTALLATIONS INSTRUCTIONS ............................... 5
Prepare Location ........................................................ 5
Install Cooktop ........................................................... 5
Make Electrical Connection ........................................ 6
Complete Installation .................................................. 7
SEGURIDAD DE LA SUPERFICIE DECOCCIÓN
........... 8
REQUISITOS DE INSTALACIÓN
.................................... 9
Herramientas y piezas ................................................ 9
Requisitos de ubicación ............................................. 9
Requisitos eléctricos ................................................. 11
INSTRUCCIONES DE INSTALACIÓN ........................ 11
Preparación de la ubicación ..................................... 11
Instalación de la supercie decocción ....................... 11
Cómo hacer la conexión eléctrica ............................. 12
Finalización de la instalación .................................... 13
IMPORTANT: READ AND SAVE THESE INSTRUCTIONS.
FOR RESIDENTIAL USE ONLY.
IMPORTANTE: LEA Y GUARDE ESTAS INSTRUCCIONES.
SOLO PARA USO RESIDENCIAL.
2
COOKTOP SAFETY
You can be killed or seriously injured if you don't immediately
You can be killed or seriously injured if you don't
follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING
3
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed here.
Tools Needed
■ Flat-blade screwdriver
■ Gloves
Parts Supplied
■ Gasket
■ Clips
Check local codes. Check existing electrical supply. See
“Electrical Requirements”.
It is recommended that all electrical connections be made by a
licensed, qualied electrical installer.
Location Requirements
Make sure you have everything needed for correct installation. It
is the responsibility of the installer to comply with the installation
clearances specied in these instructions.
IMPORTANT: Observe all governing codes and ordinances. When
installing cooktop, use minimum dimensions given.
■ To eliminate the risk of burns or re by reaching over the
heated surface units, cabinet storage space located above
the surface units should be avoided. If cabinet storage is to
be provided, the risk can be reduced by installing a range
hood that projects horizontally a minimum of 12.7 cm beyond
the bottom of the cabinets.
■ It is the installer’s responsibility to comply with installation
clearances specied. The model/serial rating plate is located
on the underside of the cooktop burner box.
■ For installation above the oven, refer to oven manufacturer’s
Installation Instructions for built-in undercounter use and
proper cutout dimensions.
■ Use the countertop opening dimensions that are given
with these Installation Instructions. Given dimensions are
minimum clearances and provide 0 cm clearance.
■ Grounded electrical supply is required. See “Electrical
Requirements” section.
INSTALLATION REQUIREMENTS
Product and Cabinet Dimensions
IMPORTANT: If installing a range hood or microwave hood
combination above the range, follow the range hood or microwave
hood combination installation instructions for dimensional
clearances above the cooktop surface.
NOTE: After you make the countertop cutout, some installations
may require notching down the base cabinet side walls to clear
the cooktop base. To avoid this modication, use a base cabinet
with sidewalls wider than the cutout.
0
+ 2
840 mm
R = Min. 6.5 mm
Max. 8 mm
Min. 50 mm
53 mm
4 mm
832 mm
510 mm
483 mm
860 mm
0
+ 2
490 mm
0
+ 2
863 mm
R = 11.5 mm
6mm
2 x kit 4801 211 0011
2
A
0
+ 2
513 mm
0
+ 2
490 mm
840 mm
0
+ 2
A
R = Min. 6.5mm
Max. 8mm
R = 11.5mm
4
min. 5mm
min. 45mm
min. 550mm
min. 20mm
15mm
100mm
65mm
min. 45mm
min. 550mm
60mm
min. 20mm
min. 5mm
min. 20mm
60mm
min. 20mm
5
Electrical Requirements
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge copper wire.
Electrically ground cooktop.
Failure to follow these instructions can result in death,
fire, or electrical shock.
If codes permit and a separate ground wire is used, it is
recommended that a qualied electrical installer determine that the
ground path and wire gauge are in accordance with local codes.
Check with a qualied electrical installer if you are not sure the
cooktop is properly grounded.
Before You Make the Electrical Connection:
To properly install your cooktop, you must determine the type of
electrical connection you will be using and follow the instructions
provided for it here.
■ The cooktop should be connected directly to the junction box
through exible, armored or nonmetallic sheathed, copper
cable. The exible, armored cable extending from the fuse
box or circuit breaker box should be connected directly to the
junction box.
■ Locate the junction box to allow as much slack as possible
between the junction box and the cooktop so that the cooktop
can be moved if servicing becomes necessary in the future.
■ If the house has aluminum wiring, follow the procedure below:
■ Connect the aluminum wiring using special connectors and/or
tools designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer’s recommended
procedure. Aluminum/copper connection must conform with local
codes and industry accepted wiring practices.
Prepare Location
1. Decide on the nal location for the cooktop.
2. If necessary, make cutout in countertop before installing
cooktop. See “Location Requirements” section for more
information.
3. Clean cutout of any remaining dust and debris.
Install Cooktop
Excessive Weight Hazard
Use two or more people to move and install cooktop.
Failure to do so can result in back or other injury.
WARNING
1. Using 2 or more people, place the cooktop upside down
on a covered surface using the foam end posts from the
packaging.
2. Remove the foam roll from the package containing literature.
Apply foam adhesive-side down around the bottom of the
cooktop glass.
NOTE: The foam helps avoid damage to the underside of
the cooktop glass from debris and helps the cooktop sit at
on uneven counters.
3. Insert the 4 clips.
4. Lower the cooktop into the cutout and push down on
cooktop to snap the cooktop clips.
x4
2
1
2mm
x4
3
90°C
1
2
3
4
2
1
x4
INSTALLATION INSTRUCTIONS
6
Make Electrical Connection
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge copper wire.
Electrically ground cooktop.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Disconnect power.
2. See “Electrical Connection Options Chart” to complete
installation for your type of electrical connection.
Nominal electrical characteristics:
Voltage 220-240/380-415V~3N (depending on installation type
at customer, see Electrical Connection Options Chart)
Frequency 50-60Hz
Max nominal power 11,0 kW
Current 32A
Electrical Connection Options Chart
black-nero-negro-preto-μαύρος-must-melns-juodas-czarny-schwarz-noir-zwart-negru
черно-црн-črna-crno-черный-чорний-қара-černá-čierna-fekete-svart-musta-svart-sort
siyah-dubh
brown-marrone-marrón-marrom-καφέ-pruun-brūns-rudas-brązowy-braunen-brun-bruin
maro-кафяв-браон-rjava-smeđ-коричневый-коричневий-қоңыр-hnědý-hnedý-barna
brunt-ruskea-brunt-brun-kahverengi-donn
blue (gray)-blu (grigio)-azul (gris)-azul (cinza)-μπλε (γκρι)-sinine (hall)-zila (pelēka)
mėlyna(pilkas)-niebieski (szary)-blau (grau)-bleu (gris)-blauw (grijs)-albastru (gri)
синьо (сиво)-плава (сива)-modro(sivo)-plava (siva)-синий (серый)-синій (сірий)
көк (сұр)-modrý (šedá)-modrý(sivá)-kék (szürke)-blå (grå)-sininen (harmaa)-blå (grå)
blåt (gråt)-mavi (gri)-gorm (liath)
yellow/green-giallo/verde-amarillo/verde-amarelo/verdeκίτρινο/πράσινο-kollane/roheline
dzeltens/zaļš-geltona/žalia-żółty/zielony-gelb/grün-jaune/vert-geel/groen-galben/verde
жълто/зелено-жуто/зелена-rumeno/zeleno-žuto/zelena-желтый/зеленый-gul/grønn
жовтий/зелений-жасыл/сары-žlutá/zelená-žltá/zelená-sárga/zöld-keltainen/vihreä
gul/grön-gul/grøn-sarı/yeşil-buí/glas
R
S
T
N
E
=
35cm 33cm
220-240V
~
220-240V
~
220-240V3
~
230V 2 Phase 2N
~
380-415V 3 N
~
AU-UK-IRL BE NL
380-415V 2 N
~
blue-blu-azul-azul-μπλε-sinine-zila-mėlyna-niebieski-blau-bleu-blauw-albastru-синьо
плава-modro-plava-синий-синій-көк-modrý-modrý-kék-blå-sininen-blå-blåt-mavi-gorm
7
Complete Installation
1. Check that all parts are now installed. If there is an extra
part, go back through the steps to see which step was
skipped.
2. Check that you have all your tools.
3. Dispose of/recycle all packaging materials.
4. Use a mild solution of liquid household cleaner and warm
water to clean cooktop before use. Dry thoroughly with a
soft cloth. For more information, see the “Cooktop Care”
section of the Use and Care Guide.
5. Read Cooktop Use in the cooktop Use and Care Guide.
6. Reconnect power.
NOTE: If the cooktop does not work after turning on the power,
check that a circuit breaker has not tripped or a household fuse
has not blown. See “Troubleshooting” section in the Use and
Care Guide for further information.
If you need Assistance or Service:
Please refer to the “Assistance or Service” section of the Use
and Care Guide or contact the dealer from whom you purchased
your cooktop.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Hotpoint ACO 654 NE Use & Care
-
Bauknecht CTAC 8905AFS NE User guide
-
Bauknecht CTAC 8905AFS AL User guide
-
HOTPOINT/ARISTON ACPH 778 C/NE Use & Care
-
Bauknecht CTAC2 8905AFS AL Use & Care
-
-
-
-
-
Bauknecht CTAC 6645 AL User guide