Page is loading ...
Electric Blender
● 300 Watt
Model No: BL-05E
Ref. No: 898-1005
INSTRUCTIONS MANUAL
CAUTION – SAFETY INSTRUCTIONS
1. This device has been designed ONLY for home & domestic use. The manufacturer bears no responsibility for any
malfunction caused by any use which is not compliant with these instructions.
2. The device is not intended to be used in the following occasions as they are not covered by the guarantee:
• Professional use.
• In common kitchen areas which are used by stores’ staff, offices’ staff and other professional workspaces.
• In farmhouses.
• Use by customers of hotels, motels, rooms for rent etc.
3. The device must be used only from adults.
4. The device must be used only for food mixing.
5. Keep the device away from kids.
6. The device is not a toy. Children must be closely supervised when they are near the device.
7. Always treat the power cable with attention. Do not pull the power cable from its main body to unplug the device from
the power jack. Always pull it from its head. Never should you fold or bend the power cable.
8. Do not use the power cable as a handle.
9. Do not leave the power cable wedged through closed doors.
10. Do not pull the power cable around sharp edges.
11. Do not allow the power cable to touch wet or hot surfaces, or leave it hanging over the edges of tables or benches.
12. Do not use the device with any transformer or voltage converter.
13. Do not use a power cable extension with the device.
14. Always connect this device on a power jack that bears additional ground connection.
15. See after the easy accessibility of the device at any given moment in order to assure that the device can be unplugged
fast and easy from the power jack in case of any emergency.
16. Do not use the device if you see the power cable worn off, or if it has fallen or suffered any other type of damage.
Address yourselves on a specialized technician to repair the problem or replace any part.
17. Always consider the device as “active” when it is plugged in the power grid as power circulates through its power circuit
even when the switches are turned to “LOW” and “0” indications. Please note that all electrical sub-parts of the device
are under power (they keep on deriving power) even when all the witches are turned to “LOW” and “0” indications.
18. The device must always be kept indoors in dry climate, away from extreme humidity and very high or very low
temperatures. Avoid also its exposure to any type of radiation.
19. Do not use the device outdoors or in places where sprays or oxygen is used.
20. Keep sufficient distances between the device and walls.
21. Do not use the device next to the edges of a kitchen bench or table as there is a risk of falling.
22. Do not place the device near or on top of another electrical, gas or another microwave oven or washing machine. Place
the device away from flammable objects and any heat source.
23. Do not store or use the device in spots where there is a high risk of falling into a sink or water can spill the device.
24. Do not use the device with wet hands.
25. Do not use the device while you are in any contact with water.
26. Do not sink the device in water or any other type of liquid.
27. Do not touch the plugged device if it has fallen in water but pull it immediately out of the power jack.
28. Do not cover the ventilation openings of the device as overheating can be caused.
29. Do not insert any object in any slot or any other opening of the device.
30. Do not use any piece of equipment not suggested by the manufacturer. They may injure the user and/or destroy the
device.
31. Keep your fingers away from any of the device’s moving part. You can cause injury to yourself!
32. Do not touch the blades barehanded or with any other object (like hair, clothes, cooking utensils, spoons, spatulas,
knives etc.) when the device is connected with the power grid, as there is a danger of electrocution.
33. When the device is turned on, always keep enough empty space around it and among other surrounding objects in
order to allow the free flow of air. Do not place the device near flammable objects like pieces of furniture, pillows,
curtains etc. ATTENTION! Should you place the device on a surface that can cause any harm on it, we recommend
you to place below the device a protective thermal insulating surface.
34. To operate the device always place it exclusively on flat surfaces.
35. Always watch over the device when it is operating.
36. Never move the device during operation.
37. Do not detach any of the accessories while the device operates.
38. Do not attempt to add or remove ingredients to or from any of the jars with your hands, spatula or any other utensil
while the blender is connected with the power grid or operates.
39. Use only the jars included in the package.
40. Do not operate the device while the attached jar is empty.
41. Always use the device on its correct standing position.
42. Do not remove any of the jars that you use from the blender base while the device operates.
43. Do no use a spatula to mix the ingredients while the device is operating.
44. Before cleaning up the blender make sure that it is shut off and that you have disconnected the power cable from the
power grid.
45. Before removing any of the jars you use, shut the blender off.
46. Switch the knob to “0” position before disconnecting the device from the power outlet.
47. The device must always be disconnected from the power source when it is not used. Always switch off and detach the
device before moving, cleaning or storing it.
48. Never store the device while it is still hot.
49. Make sure that the device is always clean before storing it.
ΑΤΤΕΝΤΙΟΝ!
Read all the instructions carefully before you begin using the
device and keep them for future reference. In case you give this
device to someone else, see after giving this instructions
manual as well.
ΑΤΤΕΝΤΙΟΝ!
The use of the device with any other accessory other than those
suggested by the manufacturer and accompanying this device
is forbidden. The use of the device with any third-party
accessory, timer or remote control system is forbidden.
ATTENTION!
This device is not suggested for use by individuals with mental
or physical disabilities (including children) or with a lack of
knowledge and experience, unless they are under the
supervision or guidance of individuals responsible for their
safety. This device is not a toy. Children must be supervised
when they are near the device.
ATTENTION – RISK OF ELECTRIC SHOCK!
In order to avoid the danger of electrocution, do not try to open
the device for fixing it. For any repairs address yourselves to
specialized technical staff.
BEFORE THE FIRST USE
1. When you get the device out of its package, take care in disposing correctly this package off by recycling its materials
(carton and nylon).
2. Keep the plastic bags of the packaging away from infants and children until they get recycled.
3. After you remove the device from its packing, clean it with a damp cloth and not with household cleaning fluids.
Do not use hard cleaning items or wire sponges in order to clean the device or the accessories (both jars,
blades’ base)
Do not place the accessories (both jars, blades’ base) in sterilization devices.
4. Never place the main device under water flow in order to clean it. This is allowed only for its detachable accessories
(both jars and blades’ base).
5. Before connecting the device with the power grid check that the operational voltage and frequency are in accordance
with the ones referred in the technical specifications table at the end of this manual.
6. Place the device on a flat and dry surface.
7. Make sure that all parts of the device are properly mounted before setting it on operation.
8. Before using the device unfold the cord completely and make sure that it does not show any signs of wear.
9. If case you notice that there is a little smell or smoke coming out of the device during the first use, do not worry as this
is normal.
10. Never set the device on when the lid of the jar you are going to use is not in its place and properly sealed. There is a
danger of overflow.
11. Do not fill any of the jars more than their respected allowances which are marked on them with “MAX” indications.
12. Always begin the operation of the device from the lower speed “1” and gradually increase the speed level to “2”, if this
is necessary.
13. Do not use the device for more than 2 minutes continuously. Be sure to always do a pause of at least 15 seconds
between each use. If you use the device for more than 3 times a break of roughly 15 minutes is necessary to allow the
unit to cool down.
14. Let hot ingredients cool down before you mash them (Max. temperature 40
o
C)
15. Cut large ingredients into small pieces before you mash them with the device.
DEVICE PARTS AND PROPER ASSEMBLY – DISASSEMBLY
1. 600ml Jar Lid
2. 600ml Jar
3. Blades
4. Blades’ Base
5. Motor Base
6. Function Knob
7. 570ml Sports Jar
8. 570ml Sports Jar Lid
Assembly instructions
Assembly of both jars Disassembly of both jars
1. Place the motor base (5) on a smooth and dry surface.
2. Screw completely the blades’ base (4) by turning it counter-clockwise onto the jar (2) or sports jar (7) that you are
about to use. Attention: sports jar is screwed upside down, meaning with its top downside, so you must first remove
its lid with a counter-clockwise move.
3. Place the previous ensemble on the motor base (5) by adjusting it properly on the secure locking.
4. Secure it by gently pressing it down and then turning it counter-clockwise.
5. In the case of the 600ml jar (2), place its lid (1) and secure it with a clockwise move.
6. After you are sure that the function knob is set to “0”, connect the device to the power grid.
7. The device will not operate if the 600ml jar (2) or the sports jar (7) in not secured onto the motor base (5) for security
reasons.
8. To dismantle all of the add-ons please follow the reverse of the actions already described.
USING THE DEVICE
1. Make sure that the device is NOT connected to the power grid.
2. In the case of the 600ml jar (2), remove its lid (1) and screw the blades’ base (4). Then, drop inside the ingredients
you like in parts, after you have previously cut them up. Finally, in any case, secure the lid properly before every
use.
In the case of the sports jar, remove its lid (8), drop inside the ingredients you like in parts and then screw the
blades’ base (4).
3. Place the base – jar/sports jar ensemble on the motor basis and secure it by turning it clockwise.
4. The function knob (6) gives you the ability to adjust the rotational speed of the blades to the desired level. The
settings of the function knob (6) are presented below:
0 = Shutdown
1 = Low speed
2 = High speed
Pulse function offers better control of the function.
Attention: Speed must always change serially by turning the knob first on position “1” and then on position
“2” and never directly from position “0” to position “2”.
5. When the ingredients are mashed to the level you desire, shut the device down by turning the function knob to “0”
position kai disconnect the device from the power plug.
6. To empty the ready mix, remove the jar (2) or the sports jar (7) from the device by turning it counter-clockwise and
pulling it up. Then remove the lid (1) of 600ml jar (2) or the blades’ base (4) for the 570ml sports jar (7) and serve.
Useful advice
• Ingredients should be cut up before they are mashed.
• When you are working on a thick mix you must interrupt the function of the device and remove the ingredients from the
jar’s edges by moving them towards the blades (3) with a plastic spatula.
• When you are working on fruit or vegetables, raw or cooked, you must cut them in small pieces to ease the mashing
process.
• When you are working on various ingredients, it would be better if you first blend the liquids and then add the thicker
ingredients.
• When you are about to mash meat it should have no bones. Likewise, always remove fruit kernels because they can
destroy the blades.
CAUTION: Maximum Temperature for used ingredients is 40°C.
• Stabilize the jar (2) or the sports jar (7) by pushing it gently when the device operates because there is a chance of
movement. In this case, shut the device immediately down and place the jar correctly.
• If you want to fill ingredients in the 600ml jar (2), remove its lid (1) and add the ingredients. Never remove the lid (1) of
the jar (2) while the blender operates. In the case of the sports jar (7), to add ingredients, the whole process of
disassembly – reassembly must be followed.
CLEANING
• Always clean the device after each use.
• Disconnect the device and let it cool down before cleaning it.
• Clean the blender’s outer surface and its base with a slightly wet cloth so as no water passes through any slits and wipe
with a dry soft cloth.
• Pay particular attention in cleaning the blades’ base (4) in order to avoid accidents/ Use a soft cloth or sponge with
some detergent always with careful moves.
• Never sink the device’s main body in water.
• Do not use hard or corrosive detergents in any part of the device.
• Make sure that all parts of the device are completely dry after cleaning and before using them again.
• Do not use sharp objects, hard brushes or oven detergents in order to clean the device.
• Do not place any part of the device in a dishwasher.
TECHNICAL SPECIFICATIONS OF THE PRODUCT
Model:
BL-05E
Ref. No:
898-1005
Output:
Output Power:
300W
Output Frequency:
50/60Hz
Features:
- Power 300W.
- 2 function speeds & PULSE function.
- Stainless Steel blades.
- 600ml plastic jar.
Accessories:
- 570 ml TRITAN sports jar, Plastic blades’ base.
RECYCLING OF USED ELECTRICAL OR ELECTRONIC APPLIANCES
This marking indicates that this product should not be disposed with other
household wastes throughout EU. To prevent possible harm to the environment
or human health from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the
product was purchased. They can take this product for environmental safe
recycling.
PROTECT THE ENVIRONMENT
The product COMPLIES with EU directives WEEE (about recycling) and ROHS
(Restriction of the use of Certain Hazardous Substance
GUARANTEED QUALITY
All products are guaranteed for their quality.
Notes
This unit may be submitted to changes in specifications, characteristics and/or operation without prior notice to the user, in order to continue
improving and developing its technology.
You can find and download this user manual in Greek and English language in the website of our company www.vicko.gr
/
