www.fmiproducts.com
124061-01B 3
DIRECT VENT INSTALLATION
IMPORTANT: Mantel installa-
tion must be completed during
framing and venting of replace.
1. Thoroughlyreviewreplaceowner's
manual before installing mantel and
replace.
2. Place mantel base close to instal-
lation location. See Pre-Installation
Preparation in fireplace owner's
manual to determine proper location
ofreplace.
3. Position mantel on top of mantel
base, placing fireplace towards
front of mantel base to allow for ap-
proximately½''gapatrearofbase.
IMPORTANT: Use caution when
positionreplace.Basemayscratch
easily.
NOTE: Two or more people are
required for lifting replace and
mantel pieces.
4. Assemble llerkit.Attach wooden
supporttollerkitsidesusingsup-
plied #10 screws through pre-drilled
holes. See Figure 2, page 4.
5. Place ller kit assembly onto rear
base as shown in Figure 2, page 4.
Kitwillbeushwithbackofbase.
Attach assembly to base using #10
screws through pre-drilled holes
6. Place mantel top onto fireplace.
Backofmanteltopwillbeushwith
backofllerkit.
7. Attachmanteltoptollerkitusing
two #10 screws through pre-drilled
45° holes as shown in Figure 2,
page 4.
8. Ventreplaceaccordingtoreplace
owner'smanual.
Note: Dimensions called out in
manual will vary due to height of
mantel base
9. Install gas line. See Gas Line Hook-
upinreplaceowner'smanual
NOTE: If any wood pieces are missing or
damaged, contact the dealer where you
purchased this mantel for replacement. If
hardware is missing or damaged, contact
FMI PRODUCTS, LLC at 1-866-328-4537
for referral information.
You can also visit FMI PRODUCTS, LLC’s
web site at www.fmiproducts.com.