SPT 10139 Operating instructions

WA-1230H Water Pump

After you remove the housing, you can begin to remove the pump. In order to reach the

pump, you will need to get the Main board and all the wiring out of your way. There are

two zip ties, one holding a tube, and the other holding some wires together, (both are

circled in yellow below) please cut these ties.

Then you will need to remove two screws, one from the top of the box, and one from the

bottom of the box, circled in the images below.

Now pull the black box (with the board) to the side, as shown below. There are 4 screws

holding the pump down, this image shows the two front screws, remove them.

The last two screws are a little bit harder to reach, but you can find them at each corner of

the pump. One is circled below, and there is an arrow in the image pointing to where you

will find the last screw that is to be removed. After you take out these screws, you can

remove the water pump.

This manual is also suitable for

Download PDF