Cornelius FCB Pinnacle Installation guide

FCB Pinnacle
Brand
Cornelius
Model
FCB Pinnacle
Type
Installation guide

Cornelius FCB Pinnacle: A Sound Solution for Your Beverage Dispensing Needs

The Cornelius FCB Pinnacle is a soundproofing kit designed to reduce noise levels generated by your Pinnacle flavor units. With its ability to effectively dampen sound, the FCB Pinnacle creates a more peaceful and serene environment for your customers and employees.

Easy Installation:

The FCB Pinnacle is simple to install, requiring minimal technical expertise. By following the step-by-step instructions provided in the manual, you can effortlessly enhance the acoustic comfort of your establishment.

Enhanced Customer Experience:

Cornelius FCB Pinnacle: A Sound Solution for Your Beverage Dispensing Needs

The Cornelius FCB Pinnacle is a soundproofing kit designed to reduce noise levels generated by your Pinnacle flavor units. With its ability to effectively dampen sound, the FCB Pinnacle creates a more peaceful and serene environment for your customers and employees.

Easy Installation:

The FCB Pinnacle is simple to install, requiring minimal technical expertise. By following the step-by-step instructions provided in the manual, you can effortlessly enhance the acoustic comfort of your establishment.

Enhanced Customer Experience:

Sound Kit Installation Instructions
© 2007-2014, Cornelius Inc. - 1 - Publication Number: 629091427INS
INSTALLATION INSTRUCTIONS
FCB Pinnacle 2 Flavor Units
SAFETY INSTRUCTIONS
!
WARNING:
Before starting installation, read and understand all safety label and warnings on the machine. Also review and
understand all safety instructions in the owners, installation and service manuals.
Failure to comply could result in serious injury, death or damage to the equipment.
QUALIFIED SERVICE PERSONNEL
!
WARNING:
Only trained and certified electrical, plumbing and refrigeration technicians should service this unit.
All wiring and plumbing must conform to national and local codes. Failure to comply could
result in serious injury, death or equipment damage.
SAFETY PRECAUTIONS
This unit has been specifically designed to provide protection against personal injury. To ensure continued
protection observe the following:
!
WARNING:
Disconnect power to the unit before servicing. Follow all lock out/tag out procedures established by the user. Verify all
power is off to the unit before performing any work.
Failure to comply could result in serious injury, death or damage to the equipment.
CAUTION:
!
Always be sure to keep area around the unit clean and free of clutter.
Failure to keep this area clean may result in injury of equipment damage.
Revision Date: March 24, 2014 www.cornelius.com Revision: C
Sound Kit Installation Instructions
Publication Number: 629091427INS - 2 - © 2007-2014, Cornelius Inc.
INSTALLATION INSTRUCTIONS
Sound Kit Installation Procedure
Figure 1.
Materials Included
1. 2 each short covers (P/N 620053463)
2. 2 each long covers (P/N 620053464)
3. 1 each air filter (P/N 620608613)
Installation Instructions
1. Remove top cover and side panels.
2. Place side panels flat with inside of the cover facing up. Lay 2 long and 2 short covers face up, as shown,
with red tape up.
Figure 2.
Sound Kit Installation Instructions
© 2007-2014, Cornelius Inc. - 3 - Publication Number: 629091427INS
3. Carefully remove red seal cover from short cover. Turn the cover over and carefully place it on the short
louvered section, as shown.
NOTE: Placing the cover and marking the centered location before removing the red seal materials
is the ideal method for placing the covers correctly.
Figure 3.
4. Repeat Step 3 for remaining 3 covers, as shown.
Figure 4.
5. Hang side panels on unit. The panels must be flat against the side of frame. The bottom cover is a tight fit
into the frame opening. Tighten panels with screws and re-install top cover.
IMPORTANT: Blocking air-flow on both sides of units in this manner requires a minimum of 4”
clearance on back of the unit for adequate airflow to the condenser. Failure to provide this
clearance could result in compressor or condenser fan failure and voiding of the warranty.
Sound Kit Installation Instructions
Publication Number: 629091427INS - 4 - © 2007-2014, Cornelius Inc.
6. Locate condenser air filter on the back of the unit.
Figure 5.
7. Remove the condenser air filter and discard.
Figure 6.
Sound Kit Installation Instructions
© 2007-2014, Cornelius Inc. - 5 - Publication Number: 629091427INS
8. Locate green replacement filter. Insert into frame.
NOTE: The crossing steel re-enforcing bars are on the bottom of the filter.
Figure 7.
9. Push the green filter into place, as shown.
10. The unit is now ready for normal operation.
Figure 8.
Figure 9.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Cornelius FCB Pinnacle Installation guide

FCB Pinnacle
Brand
Cornelius
Model
FCB Pinnacle
Type
Installation guide

Cornelius FCB Pinnacle: A Sound Solution for Your Beverage Dispensing Needs

The Cornelius FCB Pinnacle is a soundproofing kit designed to reduce noise levels generated by your Pinnacle flavor units. With its ability to effectively dampen sound, the FCB Pinnacle creates a more peaceful and serene environment for your customers and employees.

Easy Installation:

The FCB Pinnacle is simple to install, requiring minimal technical expertise. By following the step-by-step instructions provided in the manual, you can effortlessly enhance the acoustic comfort of your establishment.

Enhanced Customer Experience:

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents