30
Instructions
Placement
• Place the automatic coffee maker on a stable and level
surface. Place the appliance in such way that it cannot tip
over.
• Do not place the appliance in close proximity to a gas or
electric stove or any other heat source.
European regulations on energy saving
NOTE:
The European Directive 2009/125/EC (Ecodesign Directive)
incorporates measurements for energy saving.
The following applies to coffee makers: The keep-warm
period is limited to max. 40 minutes after which the appliance
turns off automatically.
You benet from better safety and lower energy consumption.
Electric Connection
1. Ensure that your mains power corresponds with the speci-
cations of the appliance. The specications are printed on
the type label.
2. Connect the mains cable to a properly installed and earthed
wall outlet.
Operation
Before making coffee for the rst time operate the appliance
twice with clean water only and without paper lter. This re-
moves dust, which may have collected during transport. Follow
the instructions given under “Operation”.
Turning the appliance on/off
• Press the button to switch on the appliance. The indicator
lamp of the button lights up.
• Press the button again to turn off the appliance or to cancel
brewing. The indicator lamp of the button turns off.
Operation
1. Open the lid of the water tank.
2. Fill cold water according to the desired amount of cups of
coffee into the rear water tank. The water level is displayed
on the indicator.
NOTE:
You can use the pot to ll the water tank.
CAUTION:
Do not overll the tank! Do not ll it above the 14 mark.
3. Ensure that the lter holder is properly attached.
4. Turn over the lower fold of the paper lter (size 1x4) and
place it in the lter funnel. Then ll it with coffee powder.
5. Now close the lid of the water tank.
6. Place the jug onto the warming plate.
CAUTION: Drip stop
Your appliance comes with a drip stop. It closes when
removing the coffee pot. This prevents the coffee from
dripping onto the warming plate if there is still water in the
lter.
• Ensure that the lid is attached to the coffee pot. It
opens the drip stop.
• If there is still water in the tank, place the pot under-
neath as soon as possible. Otherwise the lter might
overow.
7. Switch on the device. The indicator lamp of the button lights
up.
The Coffee Is Ready
NOTE:
The brewing process lasts approximately 10 - 15 minutes.
• When no more coffee is owing through the lter you can
remove the pot.
• Turn the device off.
• Would you like to keep the remaining coffee warm? Leave
the appliance turned on until the end of the keep-warm
period. If you wish to keep the coffee warm even after the
keep-warm period has nished, pour the remaining coffee
into a thermal ask.
NOTE:
The lter holder can be removed from the machine by its
handle.
This makes it easier to dispose of the old coffee lter, for
example.
WARNING:
If you want to make another pot of coffee immediately, switch
off the device rst. Let it cool down with the water tank open
in order to avoid hot water splashing when relling with water.
De-scaling
De-scaling is necessary when the brewing time increases
substantially.
• Use only commercially available citrus acidbased de-scaler.
• Follow the recommended instructions for use.
WARNING:
• Afterwards you should boil fresh water in the pot three or
four times in order to rinse out residues of the descaling
agent.
• Do not use any coffee powder!
• Do not use this water for consumption.