HySecurity 318N Receiver Programming & Operations Manual

Hello! I've read the programming instructions for NICE transmitters, including models 320N and ON2E/A. This document outlines how to program the transmitters to work with the receiver, including the use of a second button for controlling another gate, and how it works with third party devices. I'm ready to answer your questions about transmitter programming and related features.
How do I program a transmitter to work with the receiver?

How do I program the second button to control another gate?

What should I do if the transmitter is used with a third-party device?

Step 1)

Step 2) Remove the Green and White wires from terminal numbers 3 and 4 on the receiver (see Figure 1) and move them to

terminal numbers 5 and 6 on the receiver (see Figure 3) .

Program Transmitters for this gate exactly as described above.

Programming Instructions For NICE Transmitters (Remotes)

Step 1)

Step 2)

Press and release the Yellow Learn Button on the receiver inside the Apollo Box (see Figure 1).

The RED Light next to the Learn Button will turn on and stay on for 5 seconds.

While the red light on the receiver is turned on, press and hold either button on your 2 Button Transmitter (see Figure 2)

until the light on the Receiver turns off, then release the Transmitter Button. Wait 1 second then press and release

transmitter button. The receiver light will blink 3 times indicating the Transmitter is programmed. You are finished.

Repeat these steps for programming additional Transmitters.

Note: When activating a Nice transmitter that has been installed in a third party device replace transmitter button

presses with device activations. Relay activation of the third party device should be set to five seconds for producing

adequate transmission during receiver learn. For instance, if using an aftermarket keypad to fire the Nice transmitter,

enter your keypad code wherever this instruction calls for a "press". *

Programming and Wiring Instructions For 2nd Button Used To

Control Another Gate in Close Proximity To Gate Controlled By Primary Button

2nd Button - For Use

ONLY with Another Gate

in Close Proximity

Primary Button

Nice 320N Nice ON2E/A

Figure 2

*ANY MODIFICATION OF AN FCC AUTHORIZED PRODUCT WITHOUT EXPRESSED WRITTEN CONSENT

FROM THAT PRODUCT'S MANUFACTURER AND REAUTHORIZATION BY THE FCC IS ILLEGAL.