ET2 Lighting E21317-10PC Installation guide

I have reviewed the installation instructions for the ET2 E21317-10PC light fixture. The document details the steps required for mounting, wiring, and installing the bulbs and crystal strings. I'm ready to answer any questions you have about the installation process or its features.
What is the green wire for?

What type of bulb is needed?

What precaution should I take with the bulbs?

Installation Instructions

Model E21317-10PC

1.Turn breakeroff for circuit on outlet where fixture is to be installed.

2.Remove mounting bracket from fixture and install to electrical box.

3.Wire fixture to wires in outlet box. Green wire is for Ground.

4.Carefully remove packaging from fixture.

5.Install fixture to bracket and tighten cap nuts so that fixture meets the wall.

6.Install inner crystal strings to metal loops on bottom of panper diagram below.It is

recommended to use glove included and not touch crystal with bare fingers.

7.Install maximum 1 x40W G9 Xenon bulbs into socket.

(Caution: Xenon bulbs get very hot and may burn you. Always make sure bulbs are off

for a minimum 10 minutes before handling)