Lux LUX 1 User manual

Page is loading ...

8

Thank you for chosing a Lux 1 Royal! To achieve the

best vacuuming results, read this instruction manual

carefully. Keep the manual for future reference.

Description

1. Cord reel

2. Start/stop

3. Display

4. Indicator lamps

5. Suction control

6. Handle

7. Dust bag cover

8. Cover unlock switch

9. Power outlet

10. Hose connector with shutter

11. Rating plate

12. Dust bag

13. Safety filter

14. Parking position (x 2)

15. Exhaust vent

16. Electric plug

17. Filter cover

18. HEPA filter

19. Hose with a) connecting piece and b) hose handle

with air vent

20.Telescopic tube

21. Dust bag

22.Crevice nozzle

23. Combination nozzle

24. Floor nozzle

When unpacking the vacuum cleaner, check that it

is undamaged and that all parts are supplied.

Operation

A. Lift the dust bag cover and make sure the dust

bag and the filter have been set correctly (see the

section on the Lux filter system below).

B. Slide away the shutter and connect the hose to

the vacuum cleaner.

C. Slide the lock switch on the telescopic tube to-

wards the hose handle. Insert the hose handle into

the telescopic tube and the telescopic tube into the

floor nozzle.

D. Adjust the length of the telescopic tube as de-

sired by sliding the lock switch on the telescopic tube

towards the hose handle.

Extend the cord (16) and connect to the mains.

Lightly press the foot pedal (2) to start and stop the

vacuum cleaner. To rewind the cord, lightly press the

foot pedal with the cord symbol (1).

E. Set the desired suction effect by lightly and repea-

tedly pressing the foot pedal (5).

Select the AUTO position for normal vacuuming. The

vacuum cleaner then automatically adjusts the suc-

tion effect depending on the surface.

F. For vacuuming with reduced suction effect, se-

lect the MIN position. The suction effect can be fur-

ther reduced by using the air vent on the hose handle.

Select the MIN position and keep the air vent open

when vacuuming curtains, etc.

G. For vacuuming very dirty floors or when using

air-powered equipment, select the MAX position.

H. When the indicator lamp for the dust bag lights,

the bag should be replaced and the motor and HEPA

filters inspected.

I. When the overheating indicator lamp blinks, the

vacuum cleaner stops operating. Disconnect the

electric plug. Replace the dust bag, check the filters

and other matters, then verify if the tube/hose is

blocked. Let the vacuum cleaner cool down and do

not use it for 30 minutes. After this, the vacuum

cleaner should be ready for use again. In case the

vacuum cleaner does not start after the following

measures have been taken, contact your Lux dealer.

J. In the AUTO position, the nozzle is adjusted au-

tomatically depending on the surface.

K. Set the carpet position on the nozzle to make

vacuuming of carpets easier.

L. Set the hard floor position on the nozzle for smooth

operation when vacuuming hard floors.

M. Press the lock switch and pull apart the nozzle

and tube. Insert the tube into the desired nozzle (re-

fer to optional accessories).

N. Clean the floor nozzle after use by using the hose

handle. To make cleaning easier, the wheels can be

removed by using a screwdriver.

O. Use the combination nozzle for vacuuming furni-

ture, shelves, furnishings, etc.

P. Attach the combination nozzle on the hose handle

so it is always within easy reach. Use the nozzle on

the telescopic tube to vacuum panels, etc.

Q. Use the crevice nozzle when vacuuming in nar-

row spaces, such as corners, joints and radiators.

Lux filter system

When inspecting/replacing filters, always disconnect

the electric plug beforehand. All products in the Lux

filter system programme can be discarded with nor-

mal household rubbish.

R. a) Dust bag with three-layer paper and automatic

closing. b) Motor filter with activated carbon. c) HEPA

clinical filter for high-performance filtering.

S. Stand the vacuum cleaner on end. Open the cover

for the dust bag and motor filter. Pull up the handle

of the dust bag and lift out the bag. Clean the inte-

rior with a dry cloth. Straighten out the new dust

bad and insert it in the compartment. Close the cover.

T. When necessary, replace the safety filter. Open

9

Specifications

Technical data

Double insulation ( )

Conforms to the EU directive for CE certifica-

tion. Safety approved according to IEC 335-1 and

335-2-2.

Max power consumption: 1230 W

Fan: Two-stage radial fan

Connecting voltage:

New Zealand 230 V/50 Hz, Australia 240 V/50 Hz

Suction power:

New Zealand 270 W, Australia 280 W

Noise level, vacuum cleaner: 67 dBA

Operating radius: 12 m

Weight: 7.8 kg

Dimensions: 557 x 259 x 241 mm

Electronics

Electronic power control

Soft start

Power down

Power outlet

Overheating protector

Static electricity protector

Lux three-way filter system

HEPA filter

Safety filter

Dust bag: 3 litre volume, automatic closing

Lux tube system

Telescopic tube with integrated crevice nozzle

Tube material: Light-weight aluminium, Ø 32 mm

Accessories

Small combination nozzle

Crevice nozzle

Radiator brush (option)

Spray container (option)

Power nozzle for carpets (option)

Power nozzle for textiles (option)

Miscellaneous

Vacuum cleaner body: Steel housing

Colour: Lux metallic

Shutter

Exhaust vent

Vertical/horisontal parking position

the dust bag cover. Lift out the dust bag. Remove

the safety filter. Insert a new Lux safety filter. Insert

the dust bag and close the cover.

U. When necessary, replace the HEPA filter. Open

the filter cover and remove the filter cassette. Insert

a new HEPA filter and close the cover.

Never vacuum liquids, broken glass or other sharp

objects. Also do not vacuum ashes or inflammable

liquids or gases.

V. For short breaks while vacuuming, set the tube

and nozzle in the parking position on the side of the

vacuum cleaner. The vacuum cleaner will then be

automatically switched off. NOTE! Switching off the

appliance in this manner is only intended for short

breaks while cleaning.

X. The vacuum cleaner is equipped with a hot air

exhaust vent. Connect the hose to the exhaust vent

from the rear. Point the hose handle in the desired

direction. Use the hot air exhaust vent to dry shoes,

boots, etc.

Optional accessories

25. The optional spray container can be fitted on your

Lux vacuum cleaner to paint, water flowers, etc. Con-

nect the hose to the exhaust vent. Insert the tube in the

spray container. Fill the container with liquid. Adjust the

spray jet with the dial a. The sprayed volume can be ad-

justed by covering the hole b.

26. Use the radiator brush for thorough vacuuming

of radiators.

27. Use the ZE3 power nozzle for effective vacuum-

ing of carpets and textiles. Connect the power nozzle

to the power outlet.

28. The Power Lux power nozzle is specially designed

for textiles. Attach the power nozzle to the hose handle

and connect it to the power outlet.

29. Turboclean is a flexible air driven accessory for

numerous applications, such as grinding, polishing,

massaging and cleaning.

Important

Y. Always store your Lux vacuum cleaner in a dry

space at room temperature with the power switch

switched off, the electric plug disconnected and the

power cord rewound. The hose and tube can be po-

sitioned as shown in the picture.

If the hose becomes blocked: Connect the hose

to the exhaust vent, insert the tube at the entrance,

then start the vacuum cleaner. If the vacuum cleaner

is switched off during use and the overheating indi-

cator lamp blinks - refer to the instructions in item I.

Before cleaning or performing maintenance of the

vacuum cleaner, be sure to disconnect the electric

plug from the wall outlet. For all other service work,

spare parts and accessories, contact your Lux dealer.

Do not pull or lift the vacuum cleaner by holding

the electric cord. Regularly inspect the cord for any

damage. NOTE! Do not use the vacuum cleaner if

the electric cord is damaged. In this case, request

an authorised Lux service centre to replace the elec-

tric cord.

Your Lux vacuum cleaner has double insulation

which is why grounding of the appliance is not nec-

essary. The vacuum cleaner should only be used by

adults.

Page is loading ...

Lux LUX 1 User manual

This manual is also suitable for

Lux LUX 1 User manual

in other languages

Other documents