2. Toro
  3. Shear Bolt Kit, Out Front Z

Toro Shear Bolt Kit, Out Front Z Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Toro Shear Bolt Kit, Out Front Z Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
The T
oro Company – 1998
Printed in USA
All Rights Reserved
FORM NO. 3321–827
INSTALLATION
INSTRUCTIONS
Part No. 99–0281
Shear Bolt Kit
Out Front Z
Loose
Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Spacer
2
Replace spacer (as required)
Shear Bolt
Lock Nut
8
8
Install new shear bolt
Installation Instructions
2
Checking
blade movement
1. Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to
“OFF” to stop the engine. Remove the key.
2. Flip up deck and lock into vertical position.
3. Remove shear bolts (Fig.1).
Note: Do not remove blade bolt when
checking blade movement.
4. Rotate blade. Blade should rotate freely. If blade
does not rotate freely, proceed to Replacing
spacer. If it does, proceed to Installing new shear
bolt (Fig.1).
5. Repeat this procedure for second blade.
Replacing
spacer
1. Remove blade bolt.
2. Remove old spacer and replace with new spacer
(Fig.1).
3. Reinstall blade bolt. Tighten blade bolt to
85–110 ft-lb (115–140 Nm) (Fig.1).
4. Proceed to Installing new shear bolt.
Installing
new shear bolt
1. Install new shear bolts and lock nuts. Tighten the
shear bolt to 80–90 in-lb (9–10 Nm) (Fig.1).
Note: Notice the direction of the shear bolts
being replaced (Fig.1).
4
5
1
3
2
Figure 1
1. Shear
Bolt
2.
Lock Nut
3.
New Spacer
4.
Blade Bolt
5.
Old Spacer
/