Part List
Home Styles Consumer Assistance: www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319
Hardware List
88 5061 601
King Headboard
C.
Post
1 Pc.
B.
Post
1 Pc.
F.
Stretcher
1 Pc.
G.
Rail
17 Pcs.
H.
Upright
3 Pcs.
D.
Stretcher
1 Pc.
E.
Stretcher
1 Pc.
A.
To p
1 Pc.
Hex Wrench
1 Pc.
Small Hex Wrench
1 Pc.
M6x16
Tapered Head Cap Bolt (short)
9 Pcs.(+1 extra)
M6x25
M6x25
Bolt
14 Pcs.(+1 extra)
Outside Plate
2 Pcs.
Inside Plate
1 Pc.
M6x50
Bolt (long)
3 Pcs.(+1 extra)
M6x38
Tapered
Head Cap Bolt (long)
17 Pcs.(+1 extra)
Tapered
Head Cap Bolt (middle)
6 Pcs.(+1 extra)
M6x16
Head Cap Bolt
4 Pcs.(+1 extra)
IMPORTANT NOTE
.
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damage occurring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure
a completed product as it was designed.
Assembly Instructions 2/3
IMPORTANT
* Please keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Do not tighten all the Head Cap Bolts until each part is properly assembled.
* Use a soft cloth between these parts and the floor.
F
G
C
B
D
E
Tapered
Head Cap Bolt (long)
Head Cap Bolt
Bolt
Bolt (long)
STEP 1
Insert Bolts and Bolts (long) into the pre-drilled
holes of Uprights (H) and Rails (G).
(See Figure 1)
Attach Uprights (H) and 17X Rails (G)
to Stretcher (D) and tighten. (See Figure 2)
Attach Stretcher (E) to unit with Tapered Head
Cap Bolts (long).
Figure 1
Figure 2
Figure 3
STEP 2
Turn the unit over.
Attach Post (B) to unit with Head Cap Bolts.
Attach Stretcher (F) to unit with Tapered Head Cap Bolts (middle).
Attach Post (C) to unit with Head Cap Bolts and Tapered Head Cap Bolts (middle).
Head Cap Bolt (middle)
(See Figure 3)
Tapered
Assembly Instructions 3/3
Inside Plate
Tapered Head Cap Bolt (short)
Tapered Head Cap Bolt (middle)
Tapered Head Cap Bolt (short)
Outside Plate
E
A
Tapered Head Cap Bolt (short)
STEP 4
Attach Top (A) to unit with Tapered Head Cap Bolts (short).
(See Figures 4 and 5)
Figure 4
Figure 5
STEP 3
Attach Outside Plates to unit with
Tapered Head Cap Bolts (short) and
Tapered Head Cap Bolts (middle).
Attach Inside Plate to unit with
Tapered Head Cap Bolts (short).
/