Bolens 11A-A44R265 Quick start guide

Type
Quick start guide

This manual is also suitable for

Remove the wing nuts and carriage bolts A.
securing the upper handle to the lower
handle.
778 -12131© 2011 11A-A44
Secure the rear wheels to the mower A.
with the hardware provided.
Use the same hole height on both sides.
Install the washer with crowned side outward.
Adjust height of front wheels, if necessary.
Starter
Rope Handle
Blade Control Handle
Tools Required:
Two • -inch wrenches (or adjustable wrenches)
• ⁄-inch wrench (or adjustable wrench)
Wing Nuts
T-Bolts
Remove T-bolts from B.
the handle brackets.
A
A
A
A
A
A
B
B
Pivot the upper A.
handle upward
Secure upper handle B.
to lower handle with
wing nuts (on outside)
and carriage bolts
removed Step 1A.
B
Insert the T-bolts B.
removed in Step 1B
through the handle
brackets to secure
the handle in place.
Pull upward on the handle until the A.
holes in lower handle line up with the
holes in the handle bracket.
B
Secure the side discharge chute B.
to the mower with the hardware provided.
B
Hold blade control handle against upper handle. A.
Slowly pull starter rope handle from engine and B.
slip starter rope into the rope guide.
Tighten rope guide wing knob.C.
Use cable tie to secure cable to lower handle.D.
A
B
C
D
1
4
2
5
3
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
Oil Fill /
Dipstick
Primer
Gas Fill
778 -12131© 2011 11A-A44
Push the primer five times.
Fill fuel tank with clean, fresh gasoline. Do not
fill above the base of fuel tank neck.
Pour the entire contents of the oil bottle (supplied)
into the oil fill. Check the oil level using the
dipstick. (Refer to the Operator’s Manual)
While standing behind the machine, pivot the Blade
Control Handle against the upper handle.
Grasp the starter rope handle and pull with quick, full-
arm stroke. If the engine does not start after five pulls,
repeat steps 8 and 9.
6
8
7
9
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
  • Page 1 1
  • Page 2 2

Bolens 11A-A44R265 Quick start guide

Type
Quick start guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI