Legrand AMTC-4 Operating instructions

AMTC-4
Legrand
Brand
Legrand
Model
AMTC-4
Type
Operating instructions

This manual is also suitable for

AMTC/25DTC Communications
Add-On Covers
INSTALLATION INSTRUCTIONS
Wiremold Electrical Systems conform to and should be installed and properly ground-
ed in compliance with requirements of the current National Electrical Code, Canadian
Electrical Code or codes administered by local authorities. All electrical products may
represent possible shock or fire hazard if improperly installed or used. Wiremold elec-
trical products are UL listed, made for interior use only and should be installed in con-
formance with current local and/or the National Electrical Code.
25DTC-ACT 25DTC-CVR AMTC-ACT AMTC-CVR
Components Included: ACT Series - One (1)
High Profile Bezel, One (1) Sheet of 30
Designation Icons (white), Two (2) Outlet ID
Labels with Clear Covers, and Two (2) Color
Matched Screw Covers.
For Replacing Existing Covers:
1. Unsnap existing 8" cover from
center divider using screwdriver
slot (screwdriver required).
2. Snap on new cover to
center divider.
3. Snap on Activate
™
bezel for
25DTC/AMTC-ACT covers.
Refer to Activate instructions
for installing inserts.
For Adding Additional Cover:
1. Unsnap main cover from center
divider (screwdriver required).
2. Cut 8" off main cover. Snap
on new communications
cover to center divider.
3. Snap on main cover to center
divider with factory cut side
placed at new seam (cut
cover edge is in ceiling).
©1997 The Wiremold Company, 60 Woodlawn Street, West Hartford, CT 06110 41256 597
Screw-
driver
Slot
  • Page 1 1

Legrand AMTC-4 Operating instructions

AMTC-4
Legrand
Brand
Legrand
Model
AMTC-4
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents