Northpoint 190481 (2) User manual

COLLECTIONHOME

vintage LED lantern

with built-in dimmer switch

BATTERY INSTALLATION

1. Remove the cover from the battery compartment, located on the bottom of the lamp.

2. Insert two“D” size batteries (not included) ensuring proper polarity and replace the

battery compartment cover.

LANTERN OPERATION

Once batteries are inserted rotate ON/OFF swiitch clockwise to turn light on and adjust

brightness by turning clockwise to brighten and counter-clockwise to dim.

Rotate switch dial counter-clockwise untill it clicks into place to turn off.

Move dome lift lever down to simulate authentic lantern lighting action.

Handle and utility ring swing upward for hand-held carrying or easy hanging.

Hanging Ring

Dome Lift Lever

On/Off &

Dimmer Switch

Rustic Copper Finish

Swing Up Wire Handle

12 Super Bright LEDs

Battery Compartment

WARNING: The artwork and design of this instruction manual are protected by United

States Copyright law and may not be reproduced, distributed, displayed, published,

or used for any purpose without prior written permission. You may not alter or