E. Emerson Tool Co C24 Operating instructions

Brand: E. Emerson Tool Co

Model: C24

Type: Operating instructions

This manual is also suitable for

C36
CW50

REPAIR INSTRUCTIONS - E. EMERSON TOOL CO. ALL IN ONE CLAMP

To Disassemble Your AIO Clamp

STEP 1 - To remove the End Cap, place the Lever in the unclamped, upright position. Turn clamp over to expose Rod and underside of the plastic parts as

pictured below. Grasp the End Cap with large pliers and lift in the direction indicated in the picture. (For 99” and 144” clamps, the screw on the

small spacer on the Rod should be loosened as well).

STEP 2 - To remove the Rod assembly, tap the Fixed Jaw with a rubber mallet. Once the Fixed Jaw is free of the clamp, the Sliding Jaw and Finger Grips

should easily slide off the clamp.

To Replace The Sliding Jaw And/Or Finger Grips

STEP 3 - If you only need to replace the Sliding Jaw, it will be removable at this point and you can skip to STEP 6 and STEP 7 to finish the reassembly. If the

Finger Grips need to be replaced instead or as well, continue with STEP 4 through STEP 7.

STEP 4 - Remove the small Pin in the end of the Rod. Save the Pin and the Spring to use when reassembling. Slide the Jaw assembly off the Rod.

STEP 5 - To reassemble, slide the three Chips (refer to illustration detail), the Finger Grips and the Spring onto the Rod. Replace the small Pin.

STEP 6 - Slip the Sliding Jaws into place with the Chips and Finger Grips and hold together while slipping them back into the clamp channel. The Fixed Jaw

is then pushed into the clamp channel. Tapping with a rubber mallet makes this easier.

STEP 7 - To replace the End Cap, move the Spring to the end of the Rod. Place the End Cap on the Rod enclosing the Spring and push against the Spring

until the End Cap slips over the end of the clamp and into place.

To Replace A Fixed Jaw And/Or Lever

STEP 3 - Remove the large Pin attaching the Lever to the Rod. Use a punch or drill set the size of the hole and tap the Pin out

STEP 4 - To reassemble, position the Fixed Jaw on the Rod, slipping the flat part of the Rod into the slot in the Fixed Jaw. Line up the hole in the Rod with

the holes in the Lever and reinsert the large Pin. A hammer should be used to tap the Pin into position.

STEP 5 - Refer to Steps 6 and 7 above to complete the reassembly.

Call 866-706-4639 or email info@eemersontool.com if we can be of any additional help.