The T
oro Company – 1998
Printed in USA
All Rights Reserved
FORM NO. 3321-508
INSTALLATION
INSTRUCTIONS
Model 22452
Rear Stabilizer
for Dingo Traction Units
Loose
Parts
DESCRIPTION QTY. USE
Rear
stabilizer
1
Install on traction unit
W
arranty Registration Card
Installation Instructions
1
1
Read before use
Installing
the Rear Stabilizer
Slide the stabilizer onto the operator platform
(Fig. 1).
m–3970
2
1
Figure 1
1. Rear
stabilizer
2.
Operator platform
Operating
Notes
The stabilizer is specifically designed for use with the
smaller diameter augers (i.e., less than 10 inches).
These augers may need extra weight to perform
effectively when digging in hard ground. The
stabilizer allows the center of balance to shift from
the rear wheels to the stabilizer, thereby increasing
the downward force exerted by the auger.
To use the rear stabilizer, drive to the location where
you will be digging, then install the stabilizer, and
begin your work. Do not attempt to move the
traction unit with the rear stabilizer installed.
/
