Dainty Home AVAN7684SI Installation guide

1. Measure the height from the floor to the top of your window frame to determine the curtain length you'll need.

Curtains should just touch the floor or pool slightly.

2. Determine where you'll hang your curtain rod based on the length of your curtains. You'll want to position curtain

brackets so your rod is about six inches above your window frame.

3. Measure the depth of your window to determine the size of your curtain brackets. You'll want curtain brackets that

extend past the depth of your window molding. If they're too shallow, your curtains won't hang properly.

4. For the best look, make sure each curtain panel is at least as wide as your window.

5. Measure up to the height of your curtain panels. From there, use a pencil and tape measure to mark curtain bracket

placements six inches from the outside edge of the window frame to allow plenty of natural light.

6. Use a screwdriver to install curtain brackets; make sure the sides are even using a level.

7. Place curtains on the rod, then hang curtains.

This manual is also suitable for

Download PDF