IO CREST SI-PEX40062 Installation guide

Troubleshooting Guide SI-PEX40062

Frequent Issues

Size Issues

Ensure that the card is connected to the right port. Since it is a PCI-e x2 Card, it needs a slot larger than

PCIe x1. See Diagram Below. It will not fit in PCIe x1 unless it has a cutout(at which point it’ll operate at

lower speeds).

Card Doesn’t Show Up

This could be caused by a couple of reasons.

1. Drivers. Please ensure the drivers are correctly installed. If you are missing the drivers, you can

acquire them at http://www.sybausa.com/index.php?route=product/product&product_id=157

under the Download Tab

2. Card is not inserted correctly/is in the wrong slot. This card can slide into PCI slots(see above).

However, it will not make proper contact and not function. It could also fail to appear if it is not

pressed in all the way. Ensure that the card is connected correctly.

If the card is inserted correctly, but not appearing in Windows, try booting to BIOS and see if the

card appears. If it does, the issue lies within Windows. If not, there may be an issue with the card or

installation.

Issues with Drives Connecting

• Ensure that the Hard Drive is functioning. See if it can be connected to from other ports on

the computer.

• Ensure the SATA cable isn’t Faulty. Test the drive with another cable

• Ensure the drivers are all installed and up to date.

Other Issues

If there are issues not covered in this guide, you can contact the Syba Support Team by emailing them at

[email protected]. They are available Monday – Friday, 9:00AM – 5:30PM Pacific Time.