C - 1/4-20 x 25mm
Screw x 16
D - 1/4-20 x 60mm
Screw x 2
A - 4mm Hex Driver x 1
To Attach Base Legs
B - Phillips Screwdriver x 1
To Adjust Doors
OLA
Designed by Louis A. Lara
These distinctive product configurations are protected by US and international
patents, trade dress, and/or copyright laws.
BDI are trademarks of Becker Designed, Inc.
All Rights reserved. © 2011 BDI
OLA 8137 Rev: 06-28-11
Component List
OLA 8137 is engineered for easy assembly. Carefully follow this procedure to prevent any damage.
Unpack and identify the components. The assembly workspace should be a non-marring surface such as clean carpet.
Use a blanket on the floor to protect cabinet during assembly.
For missing hardware pieces, please contact BDI Customer Service at customerse[email protected].
For all other concerns, please contact your BDI Retailer.
8137
ASSEMBLY INSTRUCTIONS
1
BDIUSA.COM [email protected]
Placement and Maintenance
OLA 8137 is designed for indoor use on level floors. Clean glass with glass cleaner, and wood veneer with a moist cloth.
E - Cabinet x 1
F - Metal Leg x 2
G - Wood Leg x 1
H - Glass Shelf x 1
I - Wood Shelf x 2
J - Back Panel x 2
I
F
E
J
J
H
I
F
C
D
G
C
OLA
8137
ASSEMBLY INSTRUCTIONS
2
BDIUSA.COM CUSTOMERS[email protected]
Step 1
With the help of another person, position the cabinet on it's back.
Attach
Metal Legs (F) to Cabinet (E) using Screws (C) and tighten with Hex Driver (A).
Attach
Wood Leg (G) to Cabinet (E) using Screws (D) and tighten with Hex Driver (A).
Step 2
Turn Cabinet Over and Install Back Panels
With the help of another person, position the cabinet right side up.
CAUTION: Do Not Turn Cabinet Over on the Doors.
Install Back Panels (J) to the back side of the cabinet by inserting top edge in
upper channel, then tipping bottom edge forward and into lower channel.
Recommended
2-person Step
J
J
G
F
D
C
A
Recommended
2-person Step
OLA
8137
ASSEMBLY INSTRUCTIONS
3
BDIUSA.COM CUSTOMERS[email protected]
Step 3
Adjust Levelers as necessary
2 levelers for each
Metal Leg (F) and 1 Leveler for Wood Leg (G).
Step 4
Adjust Door Hinges as necessary
Using
Phillips Screwdriver (B) adjust hinges as shown below
Turn screw to adjust door in or out from cabinet
Turn screw to adjust door tilt
Loosen screws on hinge plate
to adjust door up or down
G
F
A
A
B
-
1
-
2
-
3
