The Great Outdoors 72742-143C-L User manual

Brand: The Great Outdoors

Model: 72742-143C-L

Type: User manual

The Great Outdoors 72742-143C-L is a stylish and functional outdoor light fixture that provides ample illumination for your porch, patio, or garden. With its durable construction and weather-resistant design, this fixture is built to withstand the elements and provide years of reliable use. Installation is simple and straightforward, allowing you to quickly and easily mount it to your junction box. The fixture's compatibility with ELV and LED-compatible wall dimmer switches gives you the flexibility to adjust the brightness to suit your needs, creating the perfect ambiance for any occasion.

INSTALLATION INSTRUCTIONS

Model # 72741-143C-L/72742-143C-L/72743-143C-L

READ AND SAVE THESE INSTRUCTIONS

W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .

AVERTISSEMENT! COUPERLE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

PREPARING FOR INSTALLATION (Fig. 1)

1. Shut off power at the fuse box or circuit breaker box and

remove the old fixture including the mounting hardware.

2. Carefully unpack your new fixture and lay out all the parts

in a clear area. Take care not to misplace any small parts

necessary for installation.

3. Remove the screws (D) and the rubber washers (C) to

separate mounting plate (A) from canopy (E).

4. Attach mounting plate (A) onto the junction box with the

mounting screw (B), Note: The side of the mounting plate

marked “GND” must be face out.

CONNECTION THE WIRES (Fig. 2)

5. Connect the electrical wires as shown in Fig.2. making

sure that all wire connectors are secured. If your junction

box has a ground wire (green or bare copper), connect

the fixture’s ground wire to it. Otherwise, connect the

fixture’s ground wire directly to the mounting plate (A)

using the green screw provided.

FINISHING THE INSTALLATION (Fig.1)

6. Place canopy (E) over the mounting plate (A) and secure

with screws (D) and the rubber washers (C).

7. Insert the glass (F) into the fixture frame (I), then secure

the glass (F) to the fixture frame (I) with rubber washer

(G) and screw (H).

8. To prevent moisture from entering the outlet box and

causing a short, use clear silicone sealant to outline the

outside of fixture back plate where it meets the wall

leaving a space at bottom to allow moisture a means to

escape.(Fig.3)

Your installation is now complete. Return power to the outlet box

and test the fixture.

IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A

QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING AND

INSTALLATION.

Dimmable with ELV and/or LED compatible wall dimmer

switches.

FIG.1

Part# A-021-108216 for 72741 & A-021-

108232 for 72742 & A-021-108350 72743

- Mounting Plate

- Ground Screw*1

- Mounting Screw*2

The Great Outdoors 72742-143C-L User manual

The Great Outdoors 72742-143C-L User manual

The Great Outdoors 72742-143C-L User manual

Related papers

Other documents