Noble House 305267 Operating instructions

Type
Operating instructions

This manual is also suitable for

CAUTION: This Sofa is NOT a TOY.
Keep your child / children at bay during the assembly process.
Whenever lifting/moving the Sofa and to prevent damage to the Sofa, two adults are
needed to execute these actions.
Assembly Instructions
Sofa
Caution: You must read this before you proceed
Noble House Home Furnishings LLC
1/7
No. Picture Description Qty
A
Seat Panel with Foldable
Legs
1
B Back Cushion 2
C Arm Cushion 2
D Seat Cushion 2
No. Picture Description Qty
Allen Key 1
Bolt (M8*35mm) 5
Washer (M8*2mm) 23
Lock Nut (M8*13mm) 15
Spanner (M8*13mm) 1
Parts List
Hardware
Noble House Home Furnishings LLC
2/7
Assembly Preparation
Assembly Steps
This Sofa has multiple parts and may require up to 30 minutes to assemble. To give you an
overview of the Sofa parts, the above picture is to help you put the various parts into perspective.
Please read through the instructions below to familiarise yourself with the parts and steps before
assembly.
Before Beginning Assembly:
Seat Cushion
(D)
Seat Panel with
Foldable Legs (A)
Arm Cushion
(C)
Arm Cushion
(C)
Noble House Home Furnishings LLC
3/7
Step 2
Unpack and place all parts on a clean, non-marring surface.
2.1) Place the Seat with Foldable Legs (A) facedown, on to a clean, non-marring surface.
Lift Legs upwards and outwards until they lock into the Braces, as shown above.
2.2) Affix the Leg to the Brace using Bolt () and two Washers () with Allen Key (), as
described in the above picture.
Repeat the same process with the remained Legs.
Do not fully tighten the Bolts.
Step 1
2.1
2.2
Noble House Home Furnishings LLC
4/7
With assistance from your adult partner, turn the Sofa as pictured above and then, attach Back
Cushions (B) and Arm Cushions (C) to Seat Panel with Foldable Legs (A) by using Washers ()
and Lock Nuts () with Spanner ().
Do not fully tighten the Nuts.
Step 3
Step 4
Insert the Back Cushions (B) and Arm Cushions (C) into the Seat Panel with Foldable Legs (A) into
the correct positions as depicted above.
Noble House Home Furnishings LLC
1/7
5/7
Inspect the Sofa and make sure all parts are connected.
Gently and gracefully, sit into to the Sofa.
This would help to align all the parts at all the joint areas.
Then get off the Sofa, and in a sequential manner, proceed to tighten all Bolts and Nuts.
Then proceed to tighten all Bolts and Nuts in a sequential manner.
Whenever moving or lifting the table be sure to secure assistance from your adult partner(s).
When tightening the Bolts and Nuts, tighten sequentially.
DO NOT tighten any Bolt or Nut fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and Nuts and execute this same process.
Your Sofa is ready for use.
This Sofa can only be used on a flat, level surface.
Step 5
Noble House Home Furnishings LLC
6/7
Noble House Home Furnishings LLC
7/7
CAUTION: This Table is NOT a TOY.
Keep your child / children at bay during the assembly process.
Whenever lifting/moving the Table and to prevent damage to the Table, two adults are
needed to execute these actions.
Assembly Instructions
Table
Caution: You must read this before you proceed
Noble House Home Furnishings LLC
1/6
No. Picture Description Qty
A
Table Top with
Foldable Legs
1
No. Picture Description Qty
Allen key 1
Bolt (M8*35mm) 5
Washer (M8*2) 9
Parts List
Hardware
Noble House Home Furnishings LLC
2/6
Assembly Steps
This Table has multiple parts and may require about 20 minutes to assemble. To give you an
overview of the Table parts, the above picture is to help you put the various parts into perspective.
Please read through the instructions below to familiarise yourself with the parts and steps before
assembly.
Before
Beginning
Assembly:
Overview:
Assembly Preparation
FRONT FACING
Noble House Home Furnishings LLC
3/6
2.1) Place the Table Top with Foldable Legs (A) facedown, on to a clean, non-marring surface.
Lift Legs upwards and outwards until they lock into the Braces, as shown above.
2.2) Affix the Leg to the Brace using Bolt () and two Washers () with Allen Key (), as
described in the above picture.
Repeat the same process with the remained Legs.
Do not fully tighten the Bolts.
Step 2
Step 1
Unpack and place all parts on a clean, non-marring surface.
2.1
2.2
Noble House Home Furnishings LLC
4/6
Step 3
Stand the Table up.
Place the Table on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Apply pressure to the Table Top to ensure all parts and hardware are fully aligned.
Then proceed to tighten all Bolts in a sequential manner.
Whenever moving or lifting the table be sure to secure assistance from your adult partner(s).
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and execute this same process.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Noble House Home Furnishings LLC
5/6
Noble House Home Furnishings LLC
6/6
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13

Noble House 305267 Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI