Feedback Sports 13989 Operating instructions

13989
Brand
Feedback Sports
Model
13989
Type
Operating instructions

This manual is also suitable for

RAKK STORAGE STAND LINKING STANDS
BICYCLE & THE STAND
FIGURE 1
FEATURES
SET UP & PLACING BICYCLE IN THE STAND
SETTING UP MULTIPLE STANDS
SAMPLE CONFIGURATIONS
A: Wheel Stabilizer
B: Swing Arm
C: Lock Button
D: Spring
E: Wheel Cradle
F: Pivot Clips
G. Leg Cap
1. Place hand on Swing Arm and press against spring tension.
Push the Lock Arm button at the back of the stand and raise
the Swing Arm into position.
2. Roll the bike tire straight into the stand until it
rests in the bottom of the Wheel Cradle.
1. Adjust the Pivot Clip [F] to desired angle for configuration.
(Line, Small Circle and Large Oval set-up shown below)
2. With a flat-head screwdriver, guide the clip
over the Leg Cap as you connect the stands.
1
2
2
1
F
C
D
B
A
E
G
NOTE: Tire must be inflated to prevent bike from falling over.
NOTE: The different holes on the Pivot Clip allow spacing options of 12”, 13.5”and 15”.
SINGLE LINE SET UP
SMALL CIRCLE SET UP
LARGE OVAL SET UP
FIGURE 2
FIGURE 3
FIGURE 4
15”
  • Page 1 1

Feedback Sports 13989 Operating instructions

13989
Brand
Feedback Sports
Model
13989
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents