Mounting Instructions
Antistatic Brush (Part No. 5958678)
Edition: 3/10 · Part No. 9008694
Contents of Delivery
- Antistatic Brush
- 2 Screws DIN7984-M4x6
- Washer DIN125-A4.3
Function
The antistatic brush is made to reduce electrostatic charges
around the printhead unit.
Mounting
Danger!
Risk of death via electric shock!
X Before opening the housing cover,
disconnect the device from the mains
supply and wait at lease one minute until
the power supply unit has discharged.
► Remove the rear cover.
► Insert the screw (3) incl. washer (2) from the rear side into
the drilling (1).
!
Attention!
X Do not insert screw (3) without washer (2).
Otherwise the screw (3) protruding through
the chassis would hinder opening and closing
the printhead.
► Tighten the screw (3).
► Mount the rear cover.
► Put the antistatic brush (5) with the lower elongated hole
onto the thread of screw (3)
► Fix the antistatic brush in the upper elongated hole with the
screw (6) at the drilling (4).
Adjustment
► Load label material.
► Loosen the screw (6).
► Move the antistatic brush (5) as close as possible to the
labels without touching them with bers (7) during printing.
► Tighten the screw (6).
4
3
5
6
7
3
2
1
Germany
cab Produkttechnik
GmbH & Co KG
Postfach 1904
D-76007 Karlsruhe
Wilhelm-Schickard-Str. 14
D-76131 Karlsruhe
Telefon +49 721 6626-0
Telefax +49 721 6626-249
www.cab.de
France
cab technologies s.a.r.l.
F-67350 Niedermodern
Téléphone +33 388 722 501
www.cab.de
España
cab España S.L.
E-08304 Montaró (Barcelona)
Teléfono +34 937 414 605
www.cab.de
USA
cab Technology Inc.
Tyngsboro MA, 01879
Phone +1 978 649 0293
www.cabtechn.com
South Afrika
cab Technology (Pty.) Ltd.
2125 Randburg
Phone +27 11-886-3580
www.cab.de
cabasia@cab.de
Phone +86 21 6236-3161
2299 11C60
cabasia@cab.de
www.cabasia.net
cab (Shanghai) Trading Co.,Ltd
cab Technology Co, Ltd.
Junghe 23552, Taipei, Taiwan
Phone +886 2 8227 3966
Asia
Representatives in other countries on request.