Greatmats TapBrdKit-WA Operating instructions

Greatmats.com

877-822-6622

info@greatmats.com

Max Light Oak Vinyl Portable Tap Dance Floor 9 Tile Kit

Installation

Allow all flooring materials to acclimate to the room for 24-48 hours

Installing snap together floor tiles is a simple procedure that almost anyone can do. Follow these simple

instructions to assemble your Tap Dance Board Kit. Since no adhesives are required, this installation should

be relatively quick and easy. Your completed Tap Dance Board Kit will be 3 tiles wide and 3 tiles long.

Step 1 The tiles have 2 sides with female loops, and 2 sides with male pegs:

Step 2 Start by laying your first tile. The loops should be pointed in the direction you want to add panels:

Step 3 Place the next tile so that the pegs line up over the loops:

Greatmats.com

877-822-6622

info@greatmats.com

Max Light Oak Vinyl Portable Tap Dance Floor 9 Tile Kit - continued

Step 4 Gently step on each tile. You will hear and feel it snap into place. Repeat these steps

until your Tap Dance Board Kit is 3 tiles wide and 3 tiles long.

All tiles on any given installation should ALWAYS HAVE THE FEMALE LOOPS GOING IN THE SAME

DIRECTION.

Step 5 Now connect the borders to the tiles. With a gentle push, the borders will snap into place.

Connect a male border, with nubs to a female tile edge with loops. Connect a corner to the end of

the male border, then and connect your female borders with loops, to the corner and the male

side of the tiles. Continue for the remaining 3 sides.

Your Tap Dance Board Kit is now complete!

This manual is also suitable for

Download PDF