Honey-Can-Do BRD-01233 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Honey-Can-Do BRD-01233 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
www.honeycando.com | [email protected] | 877.2.i.can.do (877.242.2636)
CRT-01512
over the door
iron and door mount
11 in L x 4.5 in W x 15.5 in H (27.9 cm L x 11.4 cm W x 39.4 cm H)
Honey-Can-Do International2
PART/ILLUSTRATION (QTY) DESCRIPTION
PARTS LIST
(1) left board hook
I
(1) right board hook
K
(1) inside support tube
L
(2) iron hook caps
M
(2) board hook plugs
N
(1) iron hook
O
(1) support hook
P
(5) mounting screws
(optional)
P
www.honeycando.com 3
ASSEMBLY
STEP 1
Thank you for purchasing our iron & board organizer over-the-door or
wall mount. Please follow these step-by-step instructions. You should
plan to spend about 5 minutes assembling this item. Start by checking
that the parts listed above match up with the parts in your package.
1. Start by inserting the support tube (C) into the end of left board hook (A).
Pass these 2 piecesthrough the sleeve of support hook (G). Complete
step 1 by inserting the exposed end of support tube (C) into the end of
board hook (B).
NOTE ¥ These pieces will remain loose until step 2 is complete.
Honey-Can-Do International4
ASSEMBLY
STEP 2
2. Pass the ends of iron hook (F) through the holes in board hooks (A)
and (B). This will lock the board hooks together. Place iron hook caps
(D) onto the exposed ends of the iron hook (F).
www.honeycando.com 5
ASSEMBLY
STEP 3
3. Insert board hook plugs (E) into the exposed ends of the board hooks
(A) and (B).
Push board hook end plugs into
the ends of board hooks.
Honey-Can-Do International6
ASSEMBLY
FINISH
1. Your new over ther door iron and board mount is now ready to hang
on your door.
WARNING - Hang your mount in a safe place!. Irons and ironing boards
not hung properly can be a hazard if they were to fall. NEVER place a
hot iron on the iron mount.
www.honeycando.com 7
ASSEMBLY
OPTIONAL WALL MOUNTING
Wall Mounting - Your Iron and board mount can also be affixed directly
to a wall.Simply place the support hook (G) against the wall at desired
location and mark the 3 mounting holes.
Using the supplied anchors and screws securely fasten the support hook
(G) to the wall. Finish the installation by completing steps 1, 2, and 3.
LIMITED LIFETIME WARRANTY
This product is warranted to be free of defects in material and workmanship for as long as the
consumer owns the product. At Honey-Can-Do’s option, defective product will be repaired, replaced or
substituted with a product of equal value. For warranty service, e-mail Honey-Can-Do at warranties@
honeycando.com or call at (877) 242-2636 (Business Hours: 8a.m. to 4p.m. CST). You may also contact
Honey-Can-Do at 5750 McDermott Drive, Berkeley, IL 60163. Do not dispose of the defective item until or
unless you are specifically asked to do so by Honey-Can-Do as we may require return of the defective item.
Honey-Can-Do shall in no event be liable for any incidental or consequential damages. Some states do not
allow the exclusion or limitation of incidental or consequential damages, so the above exclusion may not apply
to you. This warranty gives you specific legal rights, and you may also have additional rights, which may vary
from state to state.
PLEASE RECYCLE
your source for
organization,
storage & style
111011
/