Canon MX360 User manual

Category
Fax machines
Type
User manual

This manual is also suitable for

Dedicated Fax Line
Setup Guide
MX360 or MX410
Next
Connecting The Phone Lines
NextPrevious
Connecting The Phone Lines
Next
Previous
3
Before
Wall jack
After
(Phone Cord included with Canon printer)
Wall jack
If Your Wall Plate Has Two Jacks
Use the jack that supports the fax line.
NextPrevious
4
If Your Wall Plate Has One Jack For Two Lines
If your wall jack provides one jack for two phone lines, it would be best to use a
“2 Line 3 Way Adapter.” This adapter can be purchased at most stores that sell
electronics. This device creates three plugs where there was one. One jack will
be for your voice line. The other jack can be used for your fax transactions. In
most cases, line 1 (L1) is used for phone calls; L2 is used of faxing. The third
jack (L1+L2) allows access to both lines. This is where you would plug in a 2-
line telephone, if available.
The L1 jack is usually your
voice line
The L2 jack is usually your fax line
NextPrevious
5
Fax to Phone Line Connection
First, connect one end of the supplied telephone cord to the telephone jack on
the wall.
NextPrevious
6
(Phone Cord included with Canon printer)
Wall Jack
Fax to Phone Line Connection
Next, connect the other end of the supplied telephone cord to the lower jack
(labeled “L”) on the MX360 or MX410.
NextPrevious
7
(Phone Cord included with Canon printer)
Wall Jack
Setting Up The Receive Mode
NextPrevious
Step 1
Turn on the MX360 or MX410 by
pressing the ON button.
Step 2
Press the FAX button.
NextPrevious
9
MX360 MX410
Step 4
Use the Left or Right Arrow button to
select “Receive mode set”.
Step 3
Press the Menu button
NextPrevious
10
Step 5
Press the OK button
Step 6
The “Receive mode set” screen will
appear
NextPrevious
11
Step 7
Use the Left or Right arrow button
to select “Fax only mode
Step 8
Ensure that “Fax only mode” is
displayed
NextPrevious
12
Step 9
Press the OK button
Step 10
The “Make advanced settings?
screen will appear
NextPrevious
13
Step 11
Press the FAX button
Step 12
Your MX360 or MX410 is now set to
FAX only mode. Notice that the
mode is listed on the fax standby
screen.
NextPrevious
14
To Receive A Fax
When a call comes in on the fax
line, the MX360 or MX410 will
answer the call and begin
receiving the fax.
You do not have to be home or
interact with the MX360 or MX410
to receive a fax.
Previous
15
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15

Canon MX360 User manual

Category
Fax machines
Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI