The Duco L2000022-D DucoBox Eco Boiler Control is a device that will enable your ventilation heat pump to generate as much heat as possible. If the temperature sensors at the Boiler Control register too low a temperature, the Boiler Control will activate secondary heat sources to bring the buffer tank up to temperature, helping you get the most from your ventilation heat pump and save on your energy bill.
The Duco L2000022-D DucoBox Eco Boiler Control is a device that will enable your ventilation heat pump to generate as much heat as possible. If the temperature sensors at the Boiler Control register too low a temperature, the Boiler Control will activate secondary heat sources to bring the buffer tank up to temperature, helping you get the most from your ventilation heat pump and save on your energy bill.
1
ENGLISH
L2000022-D 15.11.2021 Installation guide DucoBox Eco Boiler Control
Installation guide
ENGLISH
Boiler Control
Step by step
instructions
duco.tv
L2000022-installatiehandleiding-Boiler-Control-(en)-DRUK
installation-guide-Boiler-Control-(en)
L2000022 (Revision D | 15.11.2021)
2
ENGLISH
L2000022-D 15.11.2021 Installation guide DucoBox Eco Boiler Control
Table of contents
01 Introduction ...........................................................3
01.A Operation .......................................................3
01.B Scope of supply ............................................4
01.C Dimensions ...................................................5
02 Regulations and safety instructions ............6
03 Fitting/assembly .................................................7
03.A General guidelines .....................................7
03.B Fixing ...............................................................7
04 Wiring ......................................................................8
04.A Associated connecting cables ................8
04.B Connections ..................................................9
04.C Cabling diagram ..........................................9
05 Commissioning ................................................. 10
05.A Pairing in the network ........................... 10
05.B Removing and replacing ........................ 11
English
Vero Duco - Handelsstraat 19 - 8630 Veurne - Belgium
tel +32 58 33 00 33 - fax +32 58 33 00 44 - info@duco.eu - www.duco.eu
DUCO, HANDELSSTRAAT 19
VEURNE, B8630
09
Translation of the original instructions
See www.duco.eu for information regarding warranty, maintenance, technical data, EC declaration of
conformity etc.
Installation, connection, maintenance and repairs are to be carried out by an accredited installer. The
electronic components of this product may be live. Avoid contact with water.
2 3
ENGLISH
L2000022-D 15.11.2021 Installation guide DucoBox Eco Boiler Control
01 Introduction
Congratulations on your purchase of a new Boiler Control. We welcome you into the
DUCO family as a valued customer. We hope that you will have many years of enjoying
the use of our product.
01.A Operation
The Boiler control is a control, device which will allow the ventilation heat pump to
generate as much heat as possible. If the temperature sensors at the Boiler Control
register too low a temperature, the Boiler Control will activate the secondary heat
sources in order to bring the buffer tank up to temperature. This will enable you to get
the most from your ventilation heat pump and make the biggest savings on your energy
bill.
See www.duco.eu for a full list of recognised products.
A system with a Boiler Control consists of:
• DucoBox Eco as the primary heat source
• Secondary heat source
• Boiler Control
• DucoBox Eco temperature sensors
• Buffer tank
• System cable between DucoBox Eco and Boiler Control
4
ENGLISH
L2000022-D 15.11.2021 Installation guide DucoBox Eco Boiler Control
01.B Scope of supply
Before starting to install the DucoBox Boiler Control, check to ensure it is complete
and undamaged. The kit (23cm x 22cm x 8cm) comprises the following components:
• 1 x Boiler Control device: printed circuit board with housing
• 5 x cable glands
• 1 x 230 V mains lead
• 1 x installation guide
Index tekeningnr. Aantal Beschrijving
1 A1025445 5 Kabelwartel - M16 Gatdiam., 4-8mm kabel
2 A1025446 5 Sluitmoer Kabelwartel M16
3 A1025450 1 Powercord 3x2.5mm², 2m, CEE 7/7 plug
4 A1025512 1 Heaterboard behuizing top
4 5
ENGLISH
L2000022-D 15.11.2021 Installation guide DucoBox Eco Boiler Control
01.C Dimensions
125
193
61
125
193
61
165
61
6
ENGLISH
L2000022-D 15.11.2021 Installation guide DucoBox Eco Boiler Control
02 Regulations and
safety instructions
Only an accredited installer may install, connect, commission and perform maintenance on the DucoBox Eco
Boiler Control other than as described in this manual. The installer is responsible for installing and commissio-
ning the unit.
Always adhere to the safety instructions in the manual when installing the DucoBox Eco Boiler Control. The instal-
lation also requires to be in accordance with the general and locally applicable construction, safety and installation
regulations of the local authority and other agencies. Failure to adhere to these safety instructions, warnings, notes
and instructions could result in damage to the DucoBox Eco Boiler Control or in personal injury for which DUCO NV
cannot be held liable.
Do not install or place this product in areas where the following are present or could occur:
• Excessively fatty atmosphere.
• Corrosive or flammable gases, liquids or fumes. such as alcohol, insecticides, petrol, etc.
• Local ambient temperatures above 40°C or below -5°C
• Relative humidity above 90%, an outdoor set-up or exposure to the elements
• Obstacles that impede access to or opening the device
• Spraying with water
Fix the unit with suitable screws depending on the wall.
Check that the unit is complete and undamaged when you take it out of the packaging. If you have any doubt about
this, please contact DUCO / your DUCO sales outlet.
Do not place any objects on the unit.
Keep the manual close to your unit.
Use appropriate tools to work on the unit.
Use the unit only for applications for which it has been designed as stated in this manual.
This device is not intended to be used physically by the end customer (occupant).
This device is only suitable for residential buildings.
Electrical equipment should be handled with care:
• Never touch the unit with wet hands.
• Never touch the device when barefoot.
• When handling electronics, always take measures to inhibit ESD, such as wearing an earthed wristband.
• Ensure that the electrical circuit is not damaged.
• Ensure that before work begins, the device is isolated from the power supply by removing the power cord from
the wall socket or by switching off the fuse. (Use a measuring instrument to check that this is actually the
case!)
• Check to ensure that cables and leads are not damaged.
• If a cord is damaged, it must be replaced by the manufacturer, after-sales support or individuals with compara-
ble qualifications in order to prevent any hazard.
• Do not pull on the cord to remove the plug from the socket.
• Check that the voltage shown on the nameplate matches the local mains voltage before connecting the device.
You will find the model label on top of the unit.
• Take care to ensure that the electrical supply is a 230 V, single-phase earthed, 50/60 Hz, AC system. The device
must be connected to an earthed and fused wall socket. Make sure that the electrical system to which the unit
is connected complies with the stipulated conditions.
The user is responsible for safely removing the ventilation unit at the end of its useful life, in accordance with local-
ly applicable laws or regulations. You can also take the unit to a collection point for used electrical equipment.
7
ENGLISH
L2000022-D 15.11.2021 Installation guide DucoBox Eco Boiler Control
03 Fitting/assembly
03.A General guidelines
The DucoBox Boiler Control is to be positioned a close as possible to the Duco buffer
tank, up to a maximum of 2 metres apart. All wiring coming out of the Boiler Control
must have a clear and unimpeded passage to its end component.
03.B Fixing
Fixing the DucoBox Eco Boiler Control
1
Fix the Boiler Control through the 2 screw
holes provided. Use suitable screws (not
included) for the type of substrate.
2
Wire the components as necessary. See
below in the ‘Wiring’ chapter. Screw the
glands on.
3
Close the Boiler Control by sliding the cover
downwards over the unit until you hear a
click.
CLICK
4Drive at least one screw into the side to seal
the cover.
8
ENGLISH
L2000022-D 15.11.2021 Installation guide DucoBox Eco Boiler Control
Opening the DucoBox Eco Boiler Control
1Remove the screws on the sides.
2Slide the cover upwards.
CLICK
04 Wiring
04.A Associated connecting cables
DucoBox Boiler Control Buffer tank heater control cable – 1.5
mm² 0000-4412
DucoBox Boiler Control Temperature sensor 0000-4413
9
ENGLISH
L2000022-D 15.11.2021 Installation guide DucoBox Eco Boiler Control
04.B Connections
Boiler Control printed circuit board (PCB)
Heater
Relay1
Heater
Relay2
Temperature
sensors
Voltage free
contact1
Voltage free
contact2
Pump control
Duco Wired
Power 230VAC
INST
04.C Cabling diagram
Please refer to the information sheet for the chosen product concept. These can also
be downloaded from www.duco.eu.
10
ENGLISH
L2000022-D 15.11.2021 Installation guide DucoBox Eco Boiler Control
05 Commissioning
05.A Pairing in the network
Pair the DucoBox Eco Boiler Control with the DucoBox Eco
1
Activate advanced mode on the DucoBox Eco:
• Scroll down to ADVANCED and press enter.
• Enter the installer’s code 9876 and press
enter.
2Go to the INSTALLATION menu.
3Start the WIZARD.
4
The Wizard will now enable components
to be paired with the complete system. If
installed correctly, the Boiler Control, like
the control valves, is paired automatical-
ly as soon as the wizard is started. The
LED on the DucoBox Eco Boiler Control
will start flashing green once it has been
paired correctly.If this is not the case, the
INSTALL button on the DucoBox Eco Boiler
Control can be given a brief tap.
5
Press Enter( ) on the DucoBox Eco sever-
al times, until the Wizard has completed its
sequence and the menu is visible again.
11
ENGLISH
L2000022-D 15.11.2021 Installation guide DucoBox Eco Boiler Control
05.B Removing and replacing
The procedure for removing and replacing the DucoBox Eco Boiler Control is the same
as for any other component. Please refer to the DucoBox Eco manual for the instructi-
ons.
12
ENGLISH
L2000022-D 15.11.2021 Installation guide DucoBox Eco Boiler Control
Installed by:
L2000022 Document last modified on 15.11.2021 (revision D)
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
The Duco L2000022-D DucoBox Eco Boiler Control is a device that will enable your ventilation heat pump to generate as much heat as possible. If the temperature sensors at the Boiler Control register too low a temperature, the Boiler Control will activate secondary heat sources to bring the buffer tank up to temperature, helping you get the most from your ventilation heat pump and save on your energy bill.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Hamworthy Stratton mk2 Installation guide
-
Gledhill Torrent ECO Owner's manual
-
DCS BH1-36R-N Reference guide
-
Trianco Greenflame Eco 10kW 60k W User manual
-
Trianco Greenflame Eco 10kW 60k W igneo User manual
-
Benchmark ZWBR 7-32 RD 532i Datasheet
-
-
Daikin Altherma EHY2KOMB32AA Operating instructions
-
Sorel LHCC S45 24V Owner's manual
-
