2. Tesla
  3. 3 Auto Present Door Handle
3 Auto Present Door Handle

Tesla 3 Auto Present Door Handle Installation guide

  • Hello! I've reviewed the Tesla MODEL_3 and MODEL_Y Installation Instructions. This guide provides detailed steps on how to remove various parts such as trim, the horn cover, the door plate, and screws and waterproof plugs. I'm ready to assist you with any specific questions regarding the installation process.
  • What trim parts need to be removed?
    Where is the horn cover located?
    Which screws should be removed for the Model_3?
    What is the function of the waterproof glue plug?
1： Remove the ①②③ trim parts and 2： Remove the horn cover in figure A
above
screws shown above
3： Leverage the door plate
from the ① position above
4: The model _3 model removes the circled screws
Tesla MODEL_3\MODEL_Y Installation Instructions
5： MODEL Y models remove the screws in the
blue circle , the screws in the red circle do not
need to r emove
6: pick off the red circle in the socket (note
that
the socket can be inserted into the snaps with
a sharp -tongued camera can be easily pulled
out )
7： Remove the glass tape
8：After removing the waterproof glue plug in
the ring , drop the glass to the visible screw ,
loosen
the screw and take out the glass
(Suggestion : before taking out the glass , it is
best to stick a piece of tape on the relative
position of the glass to mark the lifting height ,
so as to facilitate the loading after the
completion of the glass separation .
9: MODEL 3 model should loosen the screws in
the ring to install the next handle
11: remove the original car hall induction parts in
the circle and install them on our hand
Tip : the original car hall induction parts , the left
door of the original car hall induction parts with
our left hand , the original car right door of the
Hall should be
installed with our right hand , the wrong will not
open the door .
10: Remove the waterproof glue plug in the ring
and release three grains
Hold the handle screws and take out the
original h a ndle
12: remove the original car
decorative strip to install to our
hand
Tip : decorative strip has three buckle
from the back of the handle top
buckle can be
_
14: First carefully look at the color of the line and the corresponding
letter number, and then insert into the corresponding original car
mother seat
15: First carefully look at the color of the line and the corresponding
letter number, and then insert into the corresponding original car
male seat
16: MODEL _Y If the left rear door and right rear door are installed in
serial number 14 and 15, this transfer wire is not required
17: Remove the screws, clips and decorative panels in the three
parts of the front passenger box
18: remove the buckle from the first driver and then pull out the
decorative board at B
Tip: The main driving decorative board is removed in the
same way as the first passenger
19: Remove the decorative panels of the main driver and the
passenger driver under the center of the original car channel to
facilitate the line of the left front door and the left rear door
The bundle and the CAN protocol harness of 20 MODEL _3 pass from
below the center.
20: 2021 MODEL _ 3 and MODEL _ Y power supply positive line is connected to the battery positive
pole in
the front cover , from the hole position in A to the deputy driver in the car , and the negative
pole is connected to the original car
22: 2020 MODEL 3 CAN Protocol Cable to
Main Driver
23: 2021 MODEL _ 3 and MODEL Y connected to the socket of the passenger
speaker host prompt : before pulling out the speaker socket ,
turn off the power from the
central control screen to prevent damage to the speaker host .
/