QUICK START GUIDE
DIGITAL TORQUE WRENCH
TABLE OF CONTENTS
How to Use
Adjusting Target Torque
Adjusting Torque Range
Adjusting Rundown Torque
Setting Unit of Measure
........................................................2
.....................................3
.....................................4
................................5
.....................................6
2
HOW TO USE
1) Set Target Torque
2) Pull trigger to max RPM
3) Tool will automatically stop prior to
Target Torque to prevent over torquing
4) Finish by hand to reach Target Torque
5) Press to save record
ADJUSTING TARGET TORQUE
Target Torque is the required torque
value for the fastener being installed.
Adjust the target torque to meet the
desired torque specifications.
Press OK
when finished
Navigate to
Target Torque
and press OK
Adjust the Target
Torque using
UP /DOWN
3
ADJUSTING TORQUE RANGE
Torque Range indicates the acceptable range
of values for a successful install event.
Adjust the Torque Range to meet the
recommended torque specifications.
Navigate to
Done and
press OK
when finished
Adjust the
Torque Range
using UP
DOWN
Navigate to
Range and
press OK /
4
ADJUSTING RUNDOWN TORQUE
Rundown Torque changes the tool’s power output.
Adjust the Rundown Torque to help
prevent over torquing of the fastener.
Use UP /DOWN
to select tool’s
Rundown Torque
and press OK
5
Navigate to
Rundown Torque
in Menu and
press OK
Navigate to top
left corner and
press OK to
go to Menu
SETTING UNIT OF MEASURE
Adjust the unit of measure to comply with the
required torque specifications of the fastener.
Select desired
Unit and press OK
Navigate to
Units in Settings
and press OK
Navigate to
Settings in Menu
and press OK
6
www.milwaukeetool.asia 961013506-01(A)
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Delta Regis ESB824 Operating instructions
-
Panasonic EYFMH1 User manual
-
-
SPX SD25 User manual
-
Atlas Copco Power Focus 3102 User manual
-
-
Mountz EZ-TORQ III Operating Instructions Manual
-
Desoutter CVIS-CVIC PC2000 1 install (6159275210) Owner's manual
-
Chicago Pneumatic SD25 Series User manual
-
Crane 1298-01 Owner's manual
