more informaon on www.innosent.de—Leading in Radar smart. comfortable. safe.
SAFETY INSTRUCTIONS
• Only skilled and instructed persons shall install and connect the devices.
• Proper experience in working with mains voltage, electrical and electronic devices is required.
• Do not connect the devices directly to mains voltage, instead use the voltage given in the manual.
• Do not wire any connecons while power is applied to the device.
• Ground the devices carefully to prevent electrical shock.
• All connectors are pin-coded and t in only one posion.
• Mount the devices carefully to prevent them from shiing or dropping.
• The case must not be opened as this will void the warranty and cause incorrect calibraon of the sensor.
• The radome must not be painted, covered or glued over, as this will impair its funcon and cause incorrect calibraon.
Grounding connecon:
a: screw
b: plain washer
c: cable lugs
d: contact washer
• Ensure adequate venlaon during operaon.
• The breather must not be covered.
• All connected plugs must be screwed mechanically stable in order to comply with protecon class IP67.
• Unused connecons should be covered with a sealing cap.
• Use a shielding for the sensor if needed to protect against environmental condions (snow, rain, dust).
• Only use fully funconal equipment (ladders, aerial work plaorm, …) when working above ground.
• Sta shall be capable of working at heights.
• Use cauon when installing the devices on or around acve roadways. Pay aenon to moving trac.
• The devices must be mounted to a s and solid support.
• Vibraon, oscillaon or any kind of movement will reduce the sensor performance.
• Make sure that your installaon methods are in accordance with local safety policy and procedures and company pracces.
The protecve conductor connecon must not be used for other purposes. It must have a permanent electrical connuity
and mechanical strength.
