JELD-WEN 2051120 Operating instructions

Type
Operating instructions

This manual is also suitable for

INSTALLATION INSTRUCTIONS
for Wood Pocket Door Frames (JII102)
Note to Installer: Provide a copy of these instructions to the building
owner. By installing this product, you acknowledge the terms and
conditions of the limited warranty as part of the terms of the sale.
Thank you for selecting JELD-WEN products. Attached are JELD-WEN’s
recommended installation instructions for Wood Pocket Door Frames.
Read these instructions thoroughly before beginning. They are designed
to work in most existing applications, however; existing conditions
may require changes to these instructions. If changes are needed, they
are made at the installer’s risk. For installations other than indicated in
these instructions, contact a building professional.
Estimated Install
Time for New
Construction
First Time: 3 hrs
Experienced: 2 hrs
Professional:
1 hr
1
2
3
4
5
6
7
8
9
10
11
12
SAFETY & HANDLING
SAFETY
Read and fully understand ALL manufacturers’ instructions before •
beginning.
Do not work alone. Two or more people are required. Use safe lifting •
techniques.
Wear protective gear (e.g. safety glasses, gloves, ear protection, etc.).•
Operate hand/power tools safely and follow manufacturer’s operating •
instructions.
Be cautious of plumbing and electrical lines when cutting into walls.•
MATERIALS & HANDLING
Inspect product for cosmetic damage and verify correct size.•
Heed material manufacturers’ handling and application instructions.•
Handle in vertical position; do not carry at or drag on oor.•
Do not put stress on joints, corners or frames.•
Store in dry, well-ventilated area in vertical, leaning position to allow •
air circulation; do not stack horizontally.
Protect from exposure to direct sunlight during storage.•
IF INJURY OCCURS, IMMEDIATELY SEEK MEDICAL ATTENTION!
INCLUDED PARTS
INCLUDED PARTS & NEEDED TOOLS
A - Face jamb
B - Top Track
C - Pre-assembled pocket frame
D - Wheel hanger
E - Adjusting bolt
F - Lock nut
G - Hanger bracket
H - (4) 1 1/2" pan head screws
I - Nylon guide
J - Adjusting wrench
NEEDED TOOLS
Tape measure•
Utility knife•
Level (4' minimum •
recommended)
Hammer•
Screw gun•
3 pound maul•
NEEDED MATERIALS
#10 x 2" screws•
Finishing supplies•
A
B
D
C
E
F
G
I
H
J
INSTALLATION INSTRUCTIONS
for Wood Pocket Door Frames (JII102)
2
1. Remove the old
door frame from
the wall. Cut back
the drywall to
match the new
opening.
2. Remove the oor
plate and non load-
bearing wall studs.
3. Frame the new
rough opening with
a new header and
jambs as needed.
4. Finish the top track
and face jamb as
desired. Attach the
top track to the pre-
assembled pocket
frame. The vertical
split jamb aligns
with top track.
Attach with screws.
5. Set pocket frame
and face jamb into
the rough opening.
Shim 4" from the
corners and at 24"
maximum intervals
until square, level,
and plumb.
6. Drive a #10 x 2"
screw through the
pocket frame and
each shim. Remove
the shipping blocks.
7. Attach the nylon
guide to the split
jamb with nails.
8. Install the hanger
brackets on top of
the door centered
at 2 1/2" from each
end.
9. Slide the rollers
into the top track.
10. Hang the door
in the track. Lift
and slide the
hanger bracket
onto the adjusting
bolt head. To
align door, turn
the adjusting
bolt head with
a wrench. When
nished adjusting,
tighten lock
nut down onto
bracket.
Please visit jeld-wen.com/resources for warranty, nishing instructions
and care and maintenance information.
Thank you for choosing
© 2009 JELD-WEN, inc. | JELD-WEN, Reliability for real life and the JW icon are registered trademarks of JELD-WEN, inc., Oregon USA.
All other trademarks are the property of their respective owners.
(06/09)
INSTALL FRAME
New
opening
size
Existing
trim
Remove
drywall
Fastening
screw
Nylon
guide
Nail
Shipping block
Screw
Door
2 1/2"
Center
on door
Hanger
bracket
Hanger
bracket
Roller
Lock
nut
Adjusting
bolt head
Top track
Existing door
frame
Floor plate
Wall
stud
Top track
Pocket
frame
Face
jamb
Rotated
180
o
Vertical
split jamb
Shim
Shim
Shim
Shipping
block
Pocket
frame
  • Page 1 1
  • Page 2 2

JELD-WEN 2051120 Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI